Separate names with a comma.
These brushes from Electrex should fit -
The OEM horns on both my Supersport 939 and my Scrambler Classic made about as much noise as a wasp in jam jar.
As does mine, but they are fixed to the seat not the subframe. I don't like they way the pull up the rear of the seat when the straps are...
Accoustafill is the stuff you want : https://www.ebay.co.uk/p/598472287
Fit a new one ASAP. With a shorter spacer tightening the rear axe nuts will put a lateral load on the bearings which could cause them to fail rapidly.
The top picture is a QD exhaust The bottom one appears to be an IXIL
It will be fine. The Supersport has a sticker on the tank next to the filler cap that says "E0 E5 E10"
The symptoms on this one are much the same except diagnostics shows the right voltage at the ECU. When the battery voltage reaches 14.4V the dash...
As far as I can tell by looking at the wiring diagrams the factory alarm does nothing more than make a noise if the bike is moved or bumped. It...
Yes, I've come to that conclusion too. No headlights when it goes into "fault' mode.
@chrisw That circuit isn't quite right for many bikes including the ST2 and most Ducatis. The warning light is wired across the left and right...
Well it's not the ECU. At start up today I measured the battery at 14.3V, the ECU read 14.1V but the dash showed 14.8V. It reads a consistent 0.7V...
Thanks @chrisw and @nelly. I'll do a diagnostic and see what the ECU says first.
I'm wondering if anyone can through some light on a problem I'm having with a 1098R I'm working on. The dash consistently read BATT and shows...
I’m posting for a friend who is desperately looking for a mono subframe and matching seat/tail unit for a 2004 999s is there anything out there ?
I think the folding feature of the SS mirrors might have a lot to do with the blurry mirrors. On mine at any rate there is a few thou of free...
The bike is now sold.
I have seen 2 original stands fail at that top weld where it joins the pivot!
These bars are from a facelift ST4s of 2004/5 or from an ST3, which clamp direct to the fork leg below the top yoke. There is a pin that locates...
No chance, unless you drilled and tapped the SS top yoke. You might get away with fitting the ST top yoke as both the SS and ST use 50mm fork...
