Separate names with a comma.
The clutch switch won't cut the engine. It only prevents the starter if the bike is in gear unless the lever is pulled.
There shouldn't be a grey wire. The wire from the stand switch to the ECU is either white/red or white and it goes to pin 38 of the grey (Body)...
I might have given you some duff information! Although the MTS1000 wiring diagram quite clearly shows 12V on the black/green wire, supplied via a...
All I can tell you is that the wiring diagram shows a white/red from the side stand loom connector directly to pin 38 of the grey 'body' connector...
Whatever is going on the ECU thinks the stand is down despite the new switch. As Paul says, check the connections to the switch. It should be just...
Your link doesn't work properly. [ATTACH]...
Sorry, only those listed above at the present time.
I sold the bike 8 years ago so this about the best I can do. I didn't use these clip-ons, they were crap. [ATTACH] The preload and rebound...
If anyone wants one. I can supply colour wiring diagrams for the '98 ST2, '00'-03 ST2/ST4, '01-'01 ST4s, '03 ST4s ABS and '05 ST4s. Also 2010...
When I had my ST4s Mike Shannon, who posts on here sometimes, manufactured a pair of stubs for me to fit on the top yoke in place of the...
It's the diagram from the handbook but I used Photoshop to add the colours.
The ST4 only uses 4 of the 6 terminals. [ATTACH] For the bike to work you only have to connect the white and yellow/black wires. To get the pilot...
I turn the engine so that the slot is vertical and turn the impeller to the same alignment then they are fairly easy to slip together with the...
When you get it lined up correctly the cover should slip on virtually flush to the inner joint
I can only think that the impeller wasn't lined up with the slot in the timing crossover shaft.
As long as the bolts to the crankcase are tight they are not a problem but the stand itself on most models isn't up to using it to lift the wheels...
That's correct.
The panniers won't fit with the Akrapovic. I use the panniers but have a Termi exhaust. [ATTACH]
I found this picture that I saved a few years ago of an ST4 based 851 lookalike. it uses the OEM tank, seat, side panels and fairing though. [ATTACH]
It will probably make no difference.
