Separate names with a comma.
Odd that the left side works but not the right. As you know the indicators are driven directly from the dash with separate outputs for front...
The bike in your pic has a different tank and seat looking more like the Mk3s.
I have a 1994 registered 907ie. Production for that models stopped in 1992. I guess that sometimes bikes sit in a showroom for a year or more...
The Vento was the last single made by Mototrans but only as a 350. They did produce a 250 Strada for 1978. [IMG] Mototrans ceased trading in 1981.
Ducati singles production ended in 1974 with the Mk3 and Desmos although Mototrans in Spain continued to build them under license until they...
My phone doesn't support it. Android 5.1 appears to be to too old! Not sure I'd want it anyway.
I don't know if the DVT uses a different blank from the pre 2015 models but the blank for the 2010-2014 models is a Silca ZA14P
I think they are usually around 3 or 4 psi but if the oil pressure is as low as that there is a serious problem anyway.
The older bikes, like the OP's, have a switch with a spade connector and 10mm x 1mm pitch thread. It is the same as used on many VWs. Later bikes...
I do electrical work for a local bike shop and most of it involves fixing charging faults, usually regulators but sometimes stators too, and...
See my reply in the other thread about pickup wiring.
I didn't use anything special for heatshrink, something like this. I can't see heat being an issue as I wouldn't expect the oil to get much hotter...
Not going to guess but I doubt it has anything to do with the Sprint filter.
Fair enough guys. If Nelly says so then I'm sure that's right. The mod does reduce a lot of the racket though and stops the plates and drum...
I have to disagree. The knocking is caused by the tabs on the friction plates moving back and forward in the slots in the drum. The more wear on...
Do a search on the "Quiet clutch mod".
It as 2-way Junior Power Timer female connector. You can get them from Polevolt.
Ooh! Not so nice. I hope you are successful.
This was mine : Before [IMG] After [IMG] I was left with very short lengths to solder to at the pickups but as an electronics technician I...
As I said above Dellorto parts are all available. You should have no trouble getting new slides.
