Separate names with a comma.
I'm guessing that sounds fantastic - wish i could do the same to my 999. The induction roar is really stifled... :/
Unwanted gift?? Blimey...
You could never syringe cold engine oil through a straw, it's much too thick. Maybe if you warm up the engine and lean the bike to the right, you...
In that case, you have no idea how overfull it actually is. There was a similar thread on here a ouple of weeks or so ago and in that case, the...
Is it still over the mark/above the window on its side stand??
Allegedly, the nut on the K&N just tears off if the filter sticks badly, so no great advantage there. Smear the rubber seal with oil and tighten...
I got one like that from Lidls - works a treat :)
Replacing the crush washer while only draining some oil would be tricky because the plug would have to be completely removed to replace the...
On my 999, I have an Oberon Streetfighter bar end mirror on the right side in order to supplement the oem mirrors. The oem mirrors leave a blind...
No idea tbh but the pressure plate is alloy, so maybe it grabs if you have a friction plate against alloy.
Yes, at some point you will get slip. I'm in the low 30s for stack height and getting no slip though. That's with 130 rwbhp
Luckily, as the pin was knocked further out, it became tighter rather than looser, which alerted me to the fact it was being twisted, otherwise...
Very different from my 999 then - lots of steels. If you wanted to lighten your lever, you could try losing one steel and one friction. It's very...
My fault I misunderstood. Luckily I got away with it :/
There may have been one or two bad words...
Clutch weight will be the same unless you ditch some doubled up steels to reduce the stack height and therefore the preload on the springs
Sorted. After much struggling, managed to jack the swing arm and motor up enough to knock the pin back in. Luckily the design is such that the...
Well now we know just knocking the pin out to grease it doesn't apply to the 999 :/
Oh yes there is and it moves... :/
I take no pleasure in saying this but it doesn't seem to apply to the 999 - my motor has dropped out of alignment with the frame and the threads...
