Separate names with a comma.
I have the Termi but no bellypan. I'd be very surprised though if you couldn't for the the bellypan, presumably Ilmberger, as the Termi system is...
Rust! My old man had an Alfasud 1.5Ti in the eighties. It went like stink and stuck to the road like glue but I've never seen a car rust like it....
Nah. Nah min. Double charge fir West Coasters but ah'll let ye aff wee the disposal fee fir yir auld engine ile :p
If you can't find leaking anywhere it doesn't mean that it's not, just that you haven't found out where. Probably from the slave and down by the...
Well jist bring them ower and they'll get din in nae time. Only 120 miles fae you fin, 30 mile closer than Ducati Glasgow.
900 barrels will fit straight onto the ST2 crankcases. The stud spacing is exactly the same. I fitted ST2 barrels and pistons (94mm) to my 907ie...
A'richt. I'll let ye aff. ;) I see whaur ye're comin fae tho. Sma'r pulleys pits mair load on the belts.
Not unsimilar to the Triumph Tina scooter.
I think you are misunderstanding the desmo valve system @finm. They are actually much easier to turn over than a conventional valve spring set up...
The handbook for my 907ie says the belts should be changed at 12,000 miles but makes no mention of time. This is dating from the early 90's and it...
Is it a single phase or 3 phase motor? If you are not going for injection there could be difficulties in triggering an ignition system. I think...
It's not just the radiator, there is also the plumbing.
Melcodiag won't connect with the KKL cable, you need an ELM 327.
I think cleaning the lens would help.
SBS are my favourites. 566HS or 706HF depending on whether your bike has the earlier brakes with a single pad retaining pin or the later brakes...
Absolutely sure. The pushrod engages into the recess in the screw with its other end bearing against the piston.
No. If the screw is adjusted too far in the piston won't come right back so the bleed hole to the reservoir will remain covered. The fluid in the...
Funny you should bring that up today. I had an email this morning from a friend who has two triumphs, a Sprint and a 1200 Scrambler and he was...
I have never used a tig welder and OP's post looked like gobbledegook to me but from the replies I have learned something new. Keep it up guys...
I haven't got stick coils on any of my current bikes so I've no idea. When you get it out I'd glue it back on with a suitable glue. You might be...
