Separate names with a comma.
Brilliant. So the ABS had effectively become disconnected from the bike. I should have thought of that.
I sold the Pantah last year - couldn't get on with the fit! But I did learn a lot about them. New belts, battery and oil and it should be fine. It...
No, it's not normal. It looks like the bottom has come off the stick coil and the spring which should locate on the terminal on the top of the...
CPS gap should be 0.7mm with the engine at the timing position. i.e. TDC on horiz cylinder, both valves closed. It is seldom the gap that is...
Well, that's a CPS failure state that I hadn't heard of before but the variety of types of failure of a CPS seems to be many and varied. It can be...
Agreed, and I considered that the problem might lie with the CPS. I have seen them fail when they get hot yet work fine when they are cold but...
OK. That suggests that there is a reduced voltage to the pump. The pump and the coils both get power from the fuel pump relay which could be...
Don't just throw it on the ground. Cats are particularly susceptible to it, they seem to like the taste. It is very poisonous even in small...
If the ignition switch was dodgy everything would go off. No starter, lights, horn, indicators, ECU, sparks, etc. If the kill switch is dodgy...
On mine it was actually the loom at the steering head but this was a multi and the loom pigtail to the sensor connector was routed badly so that...
Possibly an intermittent break in the front speed sensor cable. I had that on my Multi. It doesn't affect the speedo which gets its reading from...
It seems you have an ST3. My own preference for these bikes is Scan5MX. You will need an Android phone or tablet. You will also need a Fiat 3-pin...
What bike?
That's a really useful link. Now I'm beginning to get interested in following this up.
Interesting. I already have the cables and an ELM327 but it's using RealTerm or similar serial terminal programs that will probably defeat me.
I'm not usually bothered about frame plugs. They are far too overpriced for what they are but I came across these on ebay earlier this week and...
I think that in fact the 2018 Hyper uses the later M3D ECU as also used in the Supersport and Monsters 821 and 1200. Melcodiag should partially...
Thinking about this, I suspect that all of the current Ducatis will connect to Torque and similar apps. For 2021 to meet Euro 5 regs, all bikes...
Melcodiag will communicate with the Supersport ECU and enable a few checks and will read error codes but will NOT reset any of the service...
To the OP. Check item no.43 in this diagram. It is a rubber tube that connect the boss in the bottom of the tank the drain stub on the bottom of...
