Separate names with a comma.
Wrang word @finm. Fae The Concise Scots Dictionary: poochal ; puchal ; adj. Proud, self-assured, self-confident; cocky. There is also Puckle : a...
Yes, it's almost certainly an electrical issue. FYI, there is a crank position sensor which supplies the ECU with a signal that it uses to...
I'm trying to figure out how it managed to bend the valves on both cylinders simultaneously. A desmo engine won't allow valve/piston contact by...
Tacho on these bikes is electronic, getting it's signal from the ECU. You should check your charging voltage. One of the first signs of a low...
I didn't realise that you were using stainless wire, although there are specialist solders that will work with stainless. If TIG works that's...
Yes, reflashing. However the current generation of ECUs are a lot cleverer than previous versions so it is a bit of an unknown.
I have the T800 upmap on my Supersport but since the bike is now out of warranty I really don't care and wouldn't have done anyway. It's my bike...
Maybe you should ask @James - BR Special Tuning about that? As you are probably aware they are currently promoting T800 upmap for the HYP950.
You ought to learn the art of soldering cables. Those loose strands of wire at the nipple will give you grief sooner or later. Nice job your doing...
That's very reasonable. Mine was £277 for the 12 month service - £56 parts, £175 labour + vat on the total. I grudge the labour charge for...
Ha Ha! He'll be doing EC (East Coast) 300 as well.
A couple of years ago I had the same problem with my 907ie, which uses the same injection system as the 851. It ran fine at higher revs but at...
South of Inverness what Harry says but don't go as far as Aviemore, turn off for Carrbridge. My own preference is to miss out the A9 altogether....
Going south from Thurso you don't have much alternative to the A9. if you're not bothered about John o' Groats you could cut over to Wick either...
Probably should if you want to be correct. 35Nm and the bolts are in fact M10.
Unbolts the bars and refit then with the spacers under them and with 15mm longer bolts. Can't remember the size, something like M8 x 35mm.
No, they will alter the amount of fuel being injected. Possibly much too rich or too lean to allow combustion but even then I'd expect to hear...
They should terminate in the region of the side stand unless you have a charcoal canister. Just follow them back up. Yu may have to remove the...
They are M5 x 14mm. I'm surprised that yours are rusty as they are protected to some extent by the filler cap. Is the drain hole clear and the...
Any marks on the belt have been put there as an aid by someone who replaced the belts and will be of no real help in checking the belt timing. The...
