Separate names with a comma.
The problem could be with the dash itself. I have a 1200MTS, well known for dash lighting problems, and the LH flash tell-tale sometimes flashes...
The direction won't matter. At the timing position the vertical piston is half way down the inlet stroke so there is no problem rotating the cam...
The starter relay (solenoid) has two big thick wires, one direct to the battery and the other to the starter motor. The one from the battery...
Same arrangement on my 907ie. I had to cut some of the fins to clear the mirror mounting so that the fairing panel would sit fully home. [IMG]
All the Shindengen regulators + kits + cables + fittings are available from Roadster Cycle in the US.
The FH012/FH020 are less common among shunt regulators which nearly all regulators are. I don't know if they run cooler or whether they can...
Just to complicate things. These mosfet regulators work great but there are two types. Shunt regulators : Shindengen FH series, FH012A, FH020A,...
Bear in mind that a bike with a dual seat and no pillion rests will fail an MoT.
It will depend on how near to the the focal point of the reflector the LED is. At the prices the Chinese ones are selling on eBay it's worth a...
Well that is news to me. Thanks for the info.
Ian Murray are a Dynojet centre so no doubt they could sell you a Power Commander. Not really the same thing as custom map though which I'm fairly...
Vehicle manufactures are fitting complete headlights designed to operate with the LEDs that are built into them and will comply with all the E...
I too spent a lot time with LEDs and resistors making up arrays for tail lights and similar. At that time LEDS by their nature were no good for...
The Duke's Pass isn't going to you an accurate consumption figure. It's all up and down and very twisty. Good ride though :)
I used POR15 with excellent results on a 900SS but I know a guy who used it on a Monster tank then had an expensive paint job done on it. When he...
Definitely not. I get 45-50 mpg and 170-200 miles to the tank.
Ah.. Yes, I was referring to the marks on the pressure plate and spring post. Nothing to do with the marks on the plates.
Yes it definitely makes a difference. There should be an arrow next to one of the holes in the pressure plate and a notch across the top of one of...
No need to replace the loom. I would open up the loom at the point where the damage is. Cut out the damaged cable and solder in a new section with...
Look at a speedo drive from an ST2/3/4 as they have the same spindle dia as the 749/999.
