Separate names with a comma.
I also use quick-change rear (Renthal), makes future changes much easier and cheaper. As for chain length, just buy one that's longer than...
To add, check out gearing commander; https://www.gearingcommander.com/ load the preset for your bike and you'll see the standard gearing is good...
I find 15/39 ideal on my 916, easier at lower speeds, a little more acceleration and you don't lose anything at the top end because the standard...
Going to be tricky to pull that dent out due to no access to the inside. Given it's only small, probably best to get it filled with weld and then...
Italy, late to the party so to speak with road-safety measures. Back when I lived there (1980s) it was pretty much lawless in regards to motoring...
I would think the engine should be OK if it's been looked after properly but I would take a look at the valve guides, my M900 had a lot of wear in...
O/T but I needed a new gasket for the filler cap on my old Guzzi. I couldn't find a ready made one so I bought a sheet of 'rubber' to make a new...
Does it have the quick-release fuel connectors in the tank? Asking because (some 748 don't), I replaced the connectors in my 916 for the metal...
I have Marchesini 10 spoke wheels on my 916 and the spacer suits like that, about 6-7mm protruding, I think it's just how they make them. As long...
Nice looking piece and a worthy upgrade. My original tank lasted for years, I then went through 3 replacements in short order - one failing on...
My 916 connector melted many years ago, looked similar to this. I replaced the plug, the reg/rec was fine and it still works today. Just make...
Could just be a knackered connector, not uncommon but otherwise my money's on the reg/rec.
Liking the short silencer. I recall back when I had mine there were 2 lengths (or more?) of silencer and mine had the short one which had a...
Looking at the picture of the SPS brochure and the OP's bike, it appears that both have the 45-50mm mid section, unless there was a 45mm mid-pipe...
Had similar on my Monster a few years back, horizontal belt only, was due to worn tensioner bearings. Replaced them all back then and recently (5...
The termis on 916 models have 'race use only' stamped on the top of the band at the front of the can which can't be seen when the cans are fitted...
It has exactly the same text on it as the original from my '98 Biposto so, yes it is original.
I've had a couple of mirrors crack around the base but, at least one was before the support broke. It does seem that some are a tighter fit than...
My RH side support broke like the one pictured above when the bike worked it's way off the paddock stand as I was lubing the chain. Fortunately my...
I don't think it takes long before a belt will take the shape it sits in. My 5 year old belts looked like that when I removed them but now that...
