Separate names with a comma.
Depends how bad it's got. If you catch it early enough before the cementite process has properly got going you can scrub it off with emery but...
Yes, that correct.
Quite possibly it's due to cementite build up. This can occur when the brake is held on to a hot disc and pad material burns into the surface. It...
I'll try to explain. The centre tap connection (red wire) is connected to ground, so that makes the negative connection. The 2 yellow wires are...
The O-ring should sit on the lip near the top of the tank flange spigot. Make sure it is properly in place and grease the tank aperture before...
Since it seems that it's not actually going into a gear but the light is going out then the problem is likely to be the neutral switch being...
I've no idea. I haven't seen it yet. So do I. I'll be sure to let you know.
The 3 wire alternators are not actually 3-phase, they are single-phase with a centre tapped winding. This picture will give you an idea of the set...
The 1098 manual, which I'd expect to be the same, says nothing about how many times the nuts nor the studs can be used. The nuts, washers and...
You shouldn't be adjusting the throttle stop, if it's not idling it needs the TPS resetting and / or the air bleeds set correctly. You should read...
I'd forgotten about Tuneboy. Rexxer can too but the same applies.
I've emailed the app to you. You may want to edit your post and remove the email address. I never think it's a good idea to have your email on a...
Hmm. I have had no messages from the group since the end of last year, so I don't know. I can probably copy the app and send it if that helps.
Hmm. Neither am I. My bike is a 2010 so I have no problem. @chrisw might know.
No they are BAU15s. What difference do you think that would make? [IMG]
Yes, you will need to apply via Google groups or email Wit on [email protected] If you don't have the cable adaptor you can buy one from Lonelec
MultiTool Lite
When I first came to change the rear tyre on mine I had the same problem. So I took the bike to a local tyre fitting depot and they got it off...
The diode is across located in the plug to the starter solenoid, across the 2 terminals. It's function is to quench the back EMF produced when the...
Good news. Glad it was an easy fix.
