Separate names with a comma.
I've rebuilt a few heads and never noticed any tightness after replacing the bearings. Are you sure you didn't mix any of the shims up? It's...
Was in the Dolomites from the 1st to the 8th with a few others.
Agreed. Insufficient free play at the clutch lever preventing the fluid from returning to the master cylinder. Adjust the screw at the base of the...
And a lot of batteries (AGM, gel) don't have any free acid either.
You'll need to dismantle the fork to get the cap with the adjuster off. You might as well do both of them and change the oil while you are at it....
I don't know if Gunk would affect the o-rings, it's probably ok a long as you wash it off with just a hose. Any form of pressure washer could...
Yes if it's an o-ring chain, which it probably is. Petrol can get past the o-rings and wash out the internal grease which they retain. It can also...
I wouldn't take it off to clean it - unless it had a split link, but I haven't had a chain with a split link for years. I used to take them off,...
Paraffin with a brush to clean the gunge off then wipe it with an old rag.
The indicators are supplied from the dash. If the dash fuse is blown there'd be more than the indictors not working. The brake light is supplied...
There is set up for the Scrambler that cuts the vacuum hose to the canister and fits a tee piece providing a vacuum feed for the Scottoiler....
Nothing to do with the canbus. It's because the power outlets (and the satnav socket) are on the switched side of the hands free relay. So when...
Good to hear it's fixed and was nothing serious and nice to know I was right. :)
It's an electroluminescent panel built into the dash. The only answer is a new dash.
The screen screws in behind the plug. Could it have been left out by a previous owner? But as you say, you never know with Ducati. I thought the...
Yes they do. It's item 19 in the parts drawing below. You use the same 14mm hex key to undo it as for the outer cover. It should catch any of the...
No the immobiliser won't cause the bike to cut out while it's running. The key/transponder is only active at switch-on.
