Separate names with a comma.
The good old Italian tune up! And the best excuse to ride it like you stole it... ;)
I've been doing the valves on my 916 for many years and have never had a closer get tighter, and I set them nice n' tight to start with so would...
No reason that I can see why that should be so? There are those that say on the older desmoquattro where rocker failure was/is common that...
The larger clearances are there to save the dealer money by not adjusting them until they are way out. If you're going to the trouble of doing...
It's a 'figure-of-eight' aluminium bracket with (blue) rubber inserts. IIRC it's exactly the same part that holds the cans on to the rear...
I've used hairspray, seems to work fine, even on shiny/polished bars plus I don't need to buy it as I just 'borrow' it from the Mrs. I certainly...
I believe the 996R has a carbon fairing with the intake left unpainted so it's not an insert. You could fit such a fairing (expensive though) but...
I've got a clarke lift, does the job nicely. I did have an oil leak at the lifting cylinder that stopped it working a couple of years back but I...
Top cleaning, reminds me that I need to get my car to the local £5 carwash as I can't read the rear plate...
No, I only remove them for sticking a CO meter up there to get a reading for mixture trim. The reason I had to get a tap in is because I lost one...
1/8 BSP, I had to run a tap through one of mine as it was too tight and and would probably have stripped either it or the plug if I had persevered.
Yes run it with the fuel off until it stops, but I wouldn't be taking it out for a short ride with the fuel off unless you want to push it back....
You can see it through the opening of the vertical (and probably the horizontal) cylinder but you can't access it without splitting the cases. I...
I can't really imagine this is a suitable application for carbon fibre - it simply isn't strong enough to have bolts tightened onto it. I like...
Can't say for sure that the 750 is the same but the 900 and 944 (ST2) don't have an 'O' ring on the horizontal cylinder, there is no groove for it...
I got some from MVS performance in Germany; https://www.mvs-performance.de/ in anodised billet aluminium. They have an ebay shop although the...
I've got an old Optimate and a newer Ctek. Haven't needed to use them much now that I've got Motobatt batteries in all my bikes as they hold...
You know it makes sense... ;)
If you mean the forks, 1098 and 1098SF may have the same forks? But the 1098 Ohlins are 54mm at the bottom yoke compared to 52mm for the Showa...
