Separate names with a comma.
Roadside break; [IMG]
I've always used copper until I recently bought a Moto Guzzi and noticed they were all aluminium on that. I bought some aluminium washers to use...
Won't have made any difference. And even if it had, they'll be slightly softer which is probably a good thing as they're too hard for most riders...
I had the same happen on a KTM, the water pump housing had corroded through and the coolant gone into the crankcase. May not be the case here but...
And the rest, however there never was a recall even back when they were new and popping cush drives...
Contact Total Seal; http://www.totalseal.com/ for piston rings, they will undoubtedly have some that fit and for less than the Ducati parts.
I'd advise sticking to a 15t front and going +3 on the rear. There's a lot of chain tension from that power output and it's increased by using a...
I would say uneven/uneven is better for not getting a 'repeat' tooth wear pattern. I use 15/39 on the 916 but 998 has a closer ratio gearbox and...
I'd second that, very knowledgeable. Mikuni & Keihin supplier, when I've called them for (Keihin) parts they've always had them in stock.
More silencing to conform to ever increasing noise regulations?
Indeed, mine was much worse and I carried on using it for a couple of years before I got a replacement. As long as there's enough to hold it...
Make sure you grease the threads before reassembly. I've been removing/refitting my 916 rear wheel for 19 years and never needed a rattle gun to...
More trouble than it's worth. Access to the rear cylinder exhaust valves is challenging with engine in the frame but not impossible, plus you may...
Mine is a metal tank, from a Monster 'Metallica' which was a range of 900ie models with metallic paint on a steel tank. But I think all the 900...
My bike is a 'bitsa' but it has a fuel tank from an ie model which has an internal pump & filter. To avoid over-pressurising I have fitted a...
My M900 has FCR carbs and whilst I've not had a problem with flooding/leaking, I did fit a 12v electric fuel cut-off valve that is wired in...
I just spray painted the original Ducati plates on both of mine with VHT black, holds up well and cheap enough to do again anyway.
Remove the spring/clip mechanism (be careful when taking the clip out as the spring may 'ping' out across your garage and be lost), then you can...
