Separate names with a comma.
Didn't they recently reverse the parking charges in Matlock? If so maybe the council are trying to recoup some of that...
Stick the bracket/shaft in the freezer for a few hours and heat up the bearings and they should just drop on...
I use Champion plugs....... In my lawnmower (I think they're the only ones you can get?). But NGK in my bikes...
Get a proper repair done from the inside and it should be fine. The 'from the outside at the roadside' repairs are generally considered temporary...
They do but I have found if you leave them to dry out thoroughly, they shrink back to normal and with a smearing of vaseline will go back on fine....
Check the fuse for the fuel pump relay, the larger amperage of the 2 under the seat (on a 916 anyway). They get hot, especially if the filter...
For some reason 916 series bikes don't have a hole in the yoke (other than a water drain hole). I have an aftermarket Ohlins yoke on mine that...
To add, a simple test I do when fitting the clutch pack is once the plates are all fitted and everything re-assembled, pull in fully the clutch...
How so? to me it looks like you could take the caliper bolts out, remove the lock and then refit the caliper bolts, albeit you'd need shorter...
Looks well made but, what's to stop a thief with an allen key simply removing the caliper bolts and taking it off?
The stock bolts are plated steel so should be fine, I used them on my 916 with Translogic sensor, also was advised by Translogic to use stainless...
Don't know about the Ducati speed sensor but the Translogic sensor on my 916 needed to be moved slightly away so that it didn't read the body of...
Didn't remember the number but I recall when fitting the caliper that it seemed to me that even before reaching the setting it was already enough...
I use a couple of axle stands under the footrests; [IMG] As for tightening the caliper mount brackets, I always shy off the quoted torque as it...
Always said those dished plates were shite! How can a plate that doesn't make full contact with the friction plate (unless the friction plates...
Yes, they're expensive. There maybe cheaper out there if you search or, as above grind some 2mm.
Also, if you had access to a surface grinder you could get some 2mm ground down - I thought about this as I've got loads of spare 2mm but it was...
Edited to say - Sorry I meant 1.5mm not 1mm! First I tried a UK dealer but was told that although showing on the system, they couldn't order...
I needed to reduce the pack thickness on my Monster's clutch as it was a tad too thick and dragging, making finding neutral whilst stationary...
Unless they're something special then the 54mm cans will be the same size as the 50mm (and 45mm) only the inlet pipe and possibly the actual...
