Separate names with a comma.
The first thing that usually failed on the early Datetool alarms was the mercury movement sensor "switch" usually because the mercury became polluted.
Each to their own, but i definitely would not re-install it. i love this job mostly, i would almost do it for free. When i removed my own i would...
someone else will confirm but i think that might be for the diagnostic port so not needed apart from this. If you peel off the insulation tape...
I can see a couple of Ducati-type plugs but are all wires thinner gauge than Ducati loom and black? - this will confirm. Another clue will be,...
i'm not sure if this amusing story will instill confidence, but I go back to around 1979 when I was running a Fiat 500 among other cars. A...
agree with above from a cost and stress-saving approach - if you can get to a situation where it's oil-tight again then it looks like the best...
absolutely, and it's quite common to find a secondhand bike turns out to be like this. The easy clue (apart from incorrect chain length issues)...
a credit to it's owner, although struggling to sell it. [IMG]
Well done Martyn - nice to see someone take something on "by the horns" and the included pictures will help spur on anyone else who was thinking...
propah peashooter! ^ [ATTACH]
Nice picture
well i know which one i would buy.. (but looks like it's sold!)...
yes, Robert - this i know*, i just didn't want to draw that much attention - but that is immaterial now :kissing: *hence "this one then?"
I normally agree with your approach "if it ain't broke don't fix it" as to why should you suddenly have a an idle issue, but it's possible TPS and...
this one then? https://www.gumtree.com/p/ducati-motorbikes/ducati-999-2003-998-cc-/1501359939
post #3 shows the replacement item (55320122A), and went out of my way to find a view that shows the "pivot" dimple (yellow) as this area obscured...
hard to tell visually, but sounds fine. If you checked and doublechecked all hose clips for tightness (but not too tight!) then I'm sure it's...
Typically you would just "break" the union at each injector*, and/or a union at the highest point, the smallest amount until wet and then nip it...
spent many a happy evening in Petersfield usually ending with a kebab in "the square". The thing that I always found uncanny was there was just...
could be many things as usual, but as it was fine before, and I assume you've touched nothing else apart from pump swap, then I think I would...
