Separate names with a comma.
It broke because the bolts will be tightened to more than 38nm due to the longer leverage of using it straight where a setting of 38nm will...
I don't know what it is but my 916 tank is 'lined' with a black coating? It was like that from new so must have been done by Ducati. The Monster...
The axle is still 25mm and may use the same nut? but the 'fat' end that passes through the fork leg is bigger, IIRC 35mm vs. 30mm.
Showa forks will fit (Ohlins models need a larger, 56mm bottom yoke). AFAIK the brake offset should be the same but, you'd probably need the...
749 front wheel doesn't have the fitting for a speedo drive and I doubt it would be possible to machine it as you'd lose all the bearing housing?...
I used 'slic-tite' which is a fuel resistant paste but I think it's basically PTFE? Whatever it is, it hasn't leaked...
Best wishes for a full & quick recovery.
It will provide the correct torque if the spanner is at 90 degrees to the torque wrench. However If used in a straight line, as per the pic, you...
Don't know, presumably (if the rubber is the same thickness) slicks might weigh more than treaded tyres? I fitted a new Diablo Rosso III rear...
I have similar from QB carbon. They are larger than the standard and I cut out the openings in the fairings a little to suit. I did originally...
When I've tried that I usually end up dropping the clip into the engine whilst attempting to fit it, that or it 'pings' across the room. Plus...
Likewise, a real wheelie machine but the handlebars used to 'swivel' in the clamp and I broke one of the frame rails (the 'swingarm' tube) through...
I have a pdf of Ducati workshop manual for 1999, 996. At 20mb it's probably too large to email but I can upload it for you to download if you're...
I use a length of 0.4mm shim steel and a large jubilee clip. With a little oil, tighten it up to get the rings in the grooves and then back it off...
