Separate names with a comma.
Blimey, and I worry that the Wife might park a bit too close to my car in the garage so that she might rub up against the paintwork whilst getting...
Look at this pic of a 900 air-cooled engine, above the pushrod hole are a couple of holes where oil can splash onto the pushrod where it enters...
Don't see how the TPS would get the revs that high? For that speed you would need the air as well as the fuel so I would be looking for a sticking...
Personally, I'd have to clean those welds up...
I've only ever had this setup on the bike so can't compare before/after but I get the same amount of separation/movement of the plates (around 2.5...
I have an RCS16 with Oberon slave on the Monster, works fine with a nice smooth & light action on either setting (16/18 or 16/20). I have it on...
Lower the ride height, might affect handling a little but hopefully not too much if done at both ends?
The footpegs, both rider and pillion were clear anodised on my 916. AFAIK they were all the same...
HID works very well in a 916 dip headlight as it keeps the same cut-off and beam pattern but is so much brighter. I fitted a HID dip beam and a...
4.5% is a good number. I set the 916 to around that figure (difficult to get an exact reading) and it ran nicely. I then had it custom mapped by...
You are right, I was comparing a Motobatt to lead-acid Yuasa batteries, I've not tried a Yuasa AGM battery so can't comment on them.
I had 3 Yuasas on my 916, they all required a trickle charge if left more than a couple of weeks and none lasted very long. I've now got a...
Probably claim for weight reduction... ;)
Just make sure that if the compression tester needs an adaptor to fit the sparkplug hole that it is nice and tight on the tester as you don't want...
