Separate names with a comma.
If they were 15mm offset forks then the 10mm offset discs wouldn't fit, 5mm (per side) is way too much to make it fit. If the spacings of the...
When I rebuilt my Monster engine, I initially bought the 3 gaskets (centre & both side covers) but then used only threebond (gaskets have since...
Had a bit of a thing for 'Pepper'; [IMG]
That looks much better! what Ducati should have done in the first place IMO, same with the Scrambler. On another note, that's a small 'silencer'...
Could have wired it up properly so that the gear indicator shows neutral too...
A welded casing on a 700 mile engine?... :Stop:
Here you go; Share large files. Get comments. Make it great. | Hightail Spaces and yes I've just seen it is the same part no. :upyeah:
is the 998 swingarm any different to the 916?...
Does a 620ie have an immobiliser built into the dash/key?
You need to consider the artistic licence that Ducati used; when they say 'carbon bodywork' what they really mean is that it has a (single) piece...
The shape of the mounting bracket on the fork leg is quite different, apart from the spacing the 65mm mount is at a different angle. 40mm (916);...
I think the actual cans are the same on all Termis whether 45, 50, 52, 54mm etc. only the pipes are bigger up to the can. Of course there may well...
Latch bracket looks OK (same as mine) but the gap does look a little wide at the rear, is it possible the exhaust brackets are too low (try...
But if you were to use a 'speedo healer' that slows the cable drive by the relevant percentage (as above) then the same kmh speedo would...
For an MOT, you probably don't need to do anything. They don't ride the bike or even test the speedo and so wouldn't actually know if it reads in...
Indeed, I have the 1198 Ohlins which need the larger bottom yoke (although you can bore the original +3mm) but, like the Showas they need some...
I had some 916 Showas rebuilt by Ktech with their internals, radial brake mounts and ti-nitride tubes. They could have replated the originals but...
748, unless Ohlins will be 53mm top and bottom. Ohlins are 53mm top and 56mm bottom. I don't think Ducati ever fitted Ti-nitrided Showa forks to...
aI had the switch fail on my 916, IIRC Ducati want around £30 for a new one but, as above, the Vauxhall Corsa part is compatible (just make sure...
