Separate names with a comma.
The one in the toolkit is crap, here's a better one for a tenner; Laser 5338 - 25mm Ducati Front Axle Alignment Tool - Machine Mart
According to this ebay seller; DUCATI 998 ENGINE CAMSHAFT HORIZONTAL INTAKE CAM | eBay it is a cam from a standard 998.
OA-2D? if so then O (Orizzontale) = Horizontal and A (Aspirazione) = Intake, don't know about the 2D?
I've got 9 friction plates in my 916...
That's more than I remember paying but still considerably less than the plastic parts from Ducati.
Tom Parker of Preston sell the metal CPC fittings (make sure you get Viton 'O' rings) at considerably less than Ducati sells the plastic. Triumph...
On the inside, where it is flat. A common change is to drop the front to 4 rings showing, I have done this but mine was set to 3 showing when it...
Likewise I have the QB 'large' airtubes. They are no larger at the airbox fitting but are generally bigger and also wider at the front. I cut the...
I believe they came with 3 rings showing (forks) from the factory. Rear ride height is more variable, even if the rods were set to the same length...
I aim for no more than 38mm, I have aftermarket slave cylinders (that reduce clutch pull) and find that if the pack is over 38mm then finding...
By dished plate I mean the convex plates with the dot marking on one side, I've never found it makes any difference which way they are, which...
I've tried the dished plates either and both ways, I now have no dished plates at all in my clutch and I can tell no noticeable difference...
I've always followed the plenty of throttle with plenty of engine braking routine - not full throttle for the first few miles but plenty of on/off...
Here's a comparison, ST4 vs. 916 (same as 748?); [IMG] I've got the TPO 'beast' stacks on my 916 and they are both longer and wider. Bike made...
Worst case scenario is you break a pin or two, or even the body of the plug. They are cheap enough to just cut the plug off and replace...
I believe it's an AMP 'superseal' connector boot for waterproofing connectors (not sure if a 2 or 3-way?) but they're readily available on ebay...
As above pressure plate bearing has likely seized, as such when you replace it I would also replace the oil seal in the clutch end of the shaft...
You can get an ointment for that... :D
I'm glad you did. Until a couple of years ago 2v belts were around £40/pair whilst 4v belts were around £90/pair and it was often asked 'why the...
