Separate names with a comma.
Cyclecat - can be raised, turned and angle is adjustable via an eccentric but the best thing is that the bars are longer.
Got them from Harris, along with the yoke. They are an Ohlins part, I don't recall them being expensive. Here's a pic showing part the number.;...
I bought an Ohlins bottom yoke from Harris a few years back and got a pair of 'half-moon' clamps with it that let you grip it in the vice without...
Ah, my mistake. I read it as brake lines. I had a cooler line shortened at a local 'Pirtek' but they had to use the existing fitting as they don't...
I use Goodridge 'build a line' where you buy the (screw-on) banjos, available in different angles and then a hose with screw fittings at the end,...
You need a good, powerful polisher or drill with various stiffness of mops & polish along with plenty of time & determination but it's a dirty,...
Plenty of elbow grease required. Before; [IMG] After; [IMG]
I once used 'Gun gum' on my 916 exhaust as it was blowing a little at one of the midpipe joints. Did the job great but was a bastid to get the...
No it's a 17" x 5.5"
That's the correct scheme for a '98. Up to '97 they had the 'Desmoquattro' fairing decals & Ducati on the tank/nose etc., '99 saw the intro of...
I have the BMC filters on my 916 due to having carbon tubes with no filters. Bike made 118hp & 71lb/ft after a bit of fettling. The only thing I...
You shouldn't have fed it after dark... :eek:
Indeed and going slightly O/T, I was curious to know various geometry numbers re. my 916 vs. M900 so was measuring this morning and it seems odd...
Well they have to sell them somewhere, when I lived in Italy in the late '70s/early '80s the locals certainly didn't buy road tax... ;)
Both are top notch and will do a fine job, I would also recommend Cornerspeed. :upyeah:
But, you need to alter the lock bracket as the mono subframe sits higher than the biposto, so the mono seat latch pin bracket will not reach the...
Coolant empty, passing into engine - sounds like either a head gasket gone or, probably more likely coolant leaking into engine through the water...
Mine uses M8 rod ends, not least because the rear one fastens to the M8 rear caliper mounting bolt, it does use a 14mm rod though with the 8mm...
