Separate names with a comma.
This post may help as well https://www.ducatiforum.co.uk/threads/recommission-my-first-ducati.84225/page-4#post-1829501 post #62
You’ll be fine with a 2mm and a 1.5mm steel plate together as the first ones working out. :upyeah:
Try here https://www.ducatiforum.co.uk/threads/valve-shims-exchange.77986/
I would hazard a guess that if you’re losing fluid and can’t see where from then it’s the slave cylinder. If the fluid is not obviously dripping...
Just checked. ST2/4S/748/998 all 71.5cm top to bottom. The difference between the ST & 748 etc is where the top yoke sits on the fork obviously....
I’ll measure my ST’s forks and those on my Monster 1100S for you, give me a while :upyeah:
Moving the clutch lever out to its furthest position will help because it increases the movement of the master cylinder when pulled into the bar,...
Italian spec is full power as is UK spec. The speedo can easily be changed for an mph one, just photo the 2 side by side when swapping as proof of...
What you could do is to remove the plugs and put a dry cloth or tissue over the plug hole, make sure it can’t get sucked into the cylinder. Crank...
One other simple thing to try assuming you have fuel at the plugs is to put the old plugs back in and try then. At least that will eliminate any...
You could try turning the key on, let the pump prime, turn the key off, then on again so the pump primes again, do it 3 times then hit the starter...
Get a new o-ring, in fact get 2 or 3 in the same order, saves p&p snd you always have a spare. Make sure it’s sitting on the correct lip on the...
Superb job :upyeah:
My first thought was the different sngke as well but there’s no denying the Z and the D have been imprinted into the frame completely differently...
Can you post a photo of the wiring diagram? Or even better upload a pdf? It’ll save others having to search and make sure we’re all looking at the...
That was about a month ago, I’d guess the air temp was around 8c. The photo with the multimeter at 10.87 was what the old battery dropped too when...
I agree the cranking speed is good, I’m just going off my own direct experience Chris. In my case the situation was exactly as described by the OP...
The battery is FUBAR, change it, do not go down any rabbit holes until youve done that. I speak from experience, had a battery giving exactly the...
My gosh, I’d forgotten I’d gone that far in on that one :eek:. Yes, that’s how it should look if all is working perfectly and hunky dory. I’d...
I honestly don’t know, I’d try eBay but you may have to buy a complete set of steel plates . Many do without it having unknowingly cast it aside....
