Separate names with a comma.
Yesterday. Had the day off because I and three mates had an invite to The Holland & Holland shooting school. Shot 100 sporting followed by a few...
Nope. Wet flatted by hand. It's all @ our wind tunnel for paint. 1ltr of gloss black. And a 7 day turn around time. I'd better use the time to...
Quick update from last night. My evening was spent mostly filling & flatting bloody body work. :Banghead::Banghead::Banghead: Bloody hate...
Speciality Fasteners Schnorr Safety Washers | Demon Tweeks We use these buggers on our pit stop guns. stopped them shaking themselves to bits.
Nasty bit of cold tear on the rear ;)
abit more vibration. Motor was dropped performance. Oh and it kept breaking plug earth electrodes. :eek:
It's not the most scientific method. But as the mains degrade you will begin to see axial movement in the crank pins. Which in no time destroys...
First I'd check the belts are ok and the tensioners are correct. Rig up an oil pressure gauge and see how the pressure looks. Pop the little...
Only the sticker is Ohlins. That's a Sachs for sure.
Here's my 2pence worth. Carbon is only worth showing off if it's been laid up by a bloody good laminator. In a quality mould. With quality...
Increase the rebound slows the return. And if excessive can cause the pumping down effect which will alter the geometry. Too little rebound will...
I'd I have to disagree. You'd need more rebound damping to control tyre contact patch. Too much rebound causes the rear to "pump down" making...
[MEDIA] With rebound you'll normally see a variation in the width of the tear.
That's a bloody good time. Re cold tear. Try dropping the pressure by 1 psi at a time and see what pressure it cleans up at. But I'd be cautious...
Pin diameter and rod are the same. Crown height is increased to compensate. Crank pre-load I measured (granite surface plate and micron height...
999 barrel is the same height as the 749. It's the Gudgeon pin - crown diamention that's the issue. Hence the need for the Pistal pistons. I...
As Monday's go mine was epic. Got to work normal time and by 12:30. We'd had our second power outage. Popped out to see my buddy Nathan @...
Noooo. Not one bit. I did give little H the faster lane. Even strapped a GoPro on a car for a few laps. Bloody funny to watch back. It didn't...
:)[ATTACH] SCALEXTRIC
Depends on where the rebound rod had been locked up. Don't worry always adjust from fully in. You won't need all 12 clicks.
