Separate names with a comma.
I have Fren Tubo brake lines. Nice colour but a little inflexible in that they don't run nicely along the rear chain guard very well so i have...
I think most of us have been or will be in such a position at some time. I sold my 1981 Hailwood Replica for a similar reason in the early 90s....
Obsessive compulsive disorder? That OCD. I just have to get that right :-D
The belt can move the width of a 5mm allen key. Usually measured up between the two pulleys. Was a method used on desmoquattros, not sure if...
Before you put that bolt back in Liam, make sure that you polish it. I used WD40 and 400 grit W&D paper. It cam up nice and shiny which is what...
Probably not as rusty as some can get. I had one that would not budge after 3 hours of work until I got the tool and a large mallet/gimpy. I...
Like any difficult job you just need the right tool. So that you don't damage anything, get the drift tool or have a fabricator make one on their...
There's only so much "warm summer" you can handle. This is us today [ATTACH]
You also need to check that the strap that goes around the muffler body is on the right way. Mine were skewed until I worked out that the strap...
My Ducati Performance slipper in my 916 uses the standard friction plates. A tip: measure the total stack height of the whole lot when it comes...
Bienvenidos Jose. Granada is my second favourite Spanish city
Most huggers for our bikes are integrated with the chain guard so they attach with the assistance there. I've never seen a hugger on it's own. You...
You could be right there. I was of the opinion the injectors were identical. Agree that the chip needs to be checked. It could be the only thing...
a 916 will run with a 748 chip but the chip controls fueling so it would no doubt run very lean across the whole range given that the 748 is 18.3%...
With coolant, make sure the mixture is right, especially in hot climates. Too strong a mix (too much glycol) will prevent proper cooling. Also,...
I'd also pull the plates and check the wear to the friction surfaces. Also, some guys will replace their plates before they get too bad. They're a...
I'd say so. There is wear marks on it from a nut. See where it stretches to. Looks like an earth cable
About 30-40% worn IMO
