Separate names with a comma.
I have one bike but 2 engines. I have a 748 which is now an 853. I also have a 916 with big cams. I can, and have, swapped engines in about 5-6...
What year is your bike. With my 2002 748 I can start and idle the bike on the stand. Engine only cuts out if gear selected while stand is still down
Thanks Dude. Have downloaded and will print for the coffee table.
Wrong group to ask "should I ride it or keep it locked up" Short/medium term is ok but should be ridden to well hot at least every couple of...
I had a 1981 Jota in the 90s. The clutch on that was brutal.
Lucky to be able to get out this morning in the warm autumn weather [ATTACH] [ATTACH]
I agree. I have standard master and slave cylinders and 6 spring slipper and my lever is no problem in stop/start traffic. I have standard steel...
The whole engine is painted except for mating/gasket surfaces. When repainting, all loose paint should be removed and etch primer applied before...
If i remember correctly you only need to put spacers under the latch part because these two bolt holes are closer to the top as there is no seat...
I bought the hardware so that I can swap seats in a few minutes, including new light s and seat. You don't need to. You can swap over most of the...
Are you talking about the twin pinch bolts that hold the fork on the axle? Any screw like this is available from a specialist nut and bolt shop....
I have a cheap chinese unit and they are OK. Noticeably thinner plastic and won't last but mine is 3 years old and still going well. A cheap...
I have rebuilt the top end of my 748 into an 853 with new special pistons and rings. 916 cylinders are getting hard to find and the piston kits...
No problems Paul. You can see that the screws hit the mount for the oil cooler. I'm going to fit a spacer to bring the plastic panel out. It will...
I've just fitted an oil cooler to my 2002 748 (now an 854) I'm going to need spacers as the screw for the plastic v piece runs into the rubber...
Looks good to me too. I'd seal up the ECU bung when you get a sec too. Don't need the original sticker but they do look nice. I'd be inclined to...
He might need to check the clutch pack stack height. That situation indicates the stack height may be a little too short. It might be that another...
I agree that it doesn't matter which way they go but there will be a natural way for them to join the tank. There isn't too much room in there so...
[ATTACH]
[ATTACH] I doubt there is any difference in the cases of an 748R compared to a base model 748. This was a 748R case
