Separate names with a comma.
Pump and cap not included.[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH]
Me not paying attention… oh well. At least now the root cause was found, bad fuel pump filter, or pump assembly. Abit frustrating as the dealer I...
Go straight for a performance ecu?
I must confess, I briefly had the diag cable power cables on the wrong terminals…. Only briefly though:confounded:
The frustration continues! Plugged in my odb cable for jpdiag, no connection(on a new laptop but drivers etc installed) wire test shows the same...
Today I installed my radical tank and 848 fuel pump on the bike. Cutting out when coming to a stop has gone, but I am now not getting full power...
Currently in wales with the family, should have some time to tinker in the coming days.[ATTACH] [ATTACH]
I have just tested some Hammerite, and the results look good, smooth silver and gold tested on a spare cam cover.[ATTACH] [ATTACH]
Get your wallets ready for the “last race” replica helmet from agv.
Ok cheers Nelly, If that’s the case then the issue is somewhere else, I had a good idle and needles were even and steady.
From a 2005 dark with 10k miles, couple of scuffs but no dents. £200 posted pics to follow
After swapping out the air box a few weeks ago I reset the TPS, no changes where made in the diag software since then.
After doing some reading, I’m going to check the intake manifolds and try the set I have spare from my other project. If I’m still getting a low...
Fitted the little plastic dampers, needles steady but low pressure when set evenly.[ATTACH]then with the horizontal bleed all the way...
Cheap Amazon set[ATTACH]
Needles are just going crazy, leak in the vacuum system?
Thanks Nelly! I'm going to give this a try tonight.
Just to clarify @nelly , once I have the hoses connected i leave anything with tamperproof paint untouched and just adjust the air bleeds until I...
Cheers Smithy
Ok will give this a try, I’ve seen the home made manometer in the post above, but im assuming I can use a carb balancer instead?
