Separate names with a comma.
I would think a regulator problem, allowing an AC ripple voltage to get through. This will seem to disappear at higher revs as the frequency...
And when measuring low resistance values you will often get inconsistent readings just because of the lead resistance and how well they make...
'Fraid not. I'm in NE Scotland.
Get a hold of Melcodiag. It will tell you if any of the sensors are faulty or giving erroneous readings. If the air sensor says -5° when the...
The throttle bodies don't have to come off. They are only shown of thew bike in the illustrations to highlight where the adjustments are made. The...
These might be what you are looking for Stainless flanged hex nuts
The amount of fuel injected is determined by the TPS opening and engine revs modified by the air temperature and coolant temperature sensors. Most...
The carby parts list gives part numbers for the right and left halves but the 900ie gives a part number for the pair only so can't compare...
There's also the Honda NC00XT and the Aprilia Mana and a few others but I'd rather stick with the Ducati I like and I'm used to.
I'm not a aware of them, I haven't been following BSB racing but I'll check them out. This Facebook page shows a video of the Powershift in...
There is almost certainly no chance of me ever getting a test ride so I'm trying to find out if anyone has any experience with them. They are...
That's exactly why I''m thinking of fitting one. I've had a below knee amputation of my left leg. There are 2 possible push button fitments...
Has anyone on here got any experience of fitting a Translogic power shift?
Good point about the tyres. Scottish Highland roads seem to be particularly abrasive Back in the late seventies I wore out a new Metzeler ME99 in...
I've been up that way quite a lot over the years. Most of the roads are quite good. The section between Hope and Durness is mainly single track...
I bought a Facom years ago when I had an ST4s but I've hardly ever used it since as it's quite bulky and requires room for fitting it which isn't...
Never seen it but I suspect that you're right. When my Supersport came back from it's first service it had lots of yellow paint marks next to...
I've never done cylinder heads but I have ground other surfaces using that method. There's nothing difficult about it. You need a genuine flat...
Fantastic to see these Francis. I'll definitely up for a visit the next time I'm up your wye :grinning:
