Separate names with a comma.
I think he means the spherical bearings in either end of the shock which Ducati doesn't list. I replaced those in a 900ss that I used to have and...
Yes Jon, I appreciate it can be done but assumes a certain level of knowledge that the OP may not have.
Not quite so straightforward Jon. There is spacer between the spring and the fork top that needs to be pushed down against the spring and held...
Pity you're so far away, I could certainly use these.
I too had that issue with a 907ie when I changed the rear tyre from a Continental to an Avon. The Avon was a little wider and was just touching...
The coolant temperature sensor wires are white/blue and black/violet which looks like what's in the photos. if the ECU isn't getting the correct...
The coil has a laminated soft iron core which is what you are seeing. It's gotten seriously rusted and the rust has pushed the laminations apart...
I'd guess it's aftermarket. The Ducati alarm is just an alarm, relying on the bike's inbuilt immobiliser.
Petsmith's guide above should give you and idea, as long as there are no other items on that circuit that need protection with a lower fuse.
What bike is this for? The ST2/4 and early ST4s had a 3A fuse on the power outlets. This was subsequently upped to 20A on later models.
Agreed. I'd be stripping the fairing off to check for tightness of the coolant hose clamps.
It's to do with the sprocket sizes. If they are both even numbers the wear will be spread on the same teeth more often. I always try to have odd...
Do you mean the fuel pump sound? The fuel pump should run for 2-3 seconds at switch on then turn off until the engine turns over with the starter....
The RH side is for the alternator and the LH the ignition pickups. If you are removing the engine take the covers off because, as has been pointed...
Dropbox link sent.
Support and availability for Multitool ceased several years ago. I have a copy of the MultiTool Lite app which I can send you. It will clear the...
I would be a good idea to clean off the blue corrosion on the circuit board and seal it with a lacquer to prevent further corrosion.
No, there is some other cause.
Silicone stands up to a remarkable amount of heat. When my son was a lot younger he bought a VFR400 Honda that had seen better days. Several of...
P2227 is a generic error code for barometric pressure sensor, possibly indicating a faulty MAP sensor. There are two, one for each cylinder.
