Separate names with a comma.
I don't think the blackening is an issue, they seem to be well soldered to the board but some of the contacts look to be a bit pitted. A clean...
Sorry, I don't know of any way of lifting the tank without removing the beak and all the panels. This picture from the wiring diagram might help...
Owners who fit Dynacoils usually use those with a 3Ω primary resistance.
I hope you managed to convince DVLA at least. Thanks for all the interesting info above.
I had the same issue on my 2010. It had started under the hugger in front of the tyre where it gets blasted by shit thrown off the tyre. It then...
Yes, but why wreck a perfectly good speedo drive that could be used for something else. The spacer was cheap, did the job neatly and didn't...
I had to work this out a few weeks ago. I was putting a bike together for a guy and he had fitted discs from an R so needed spacers behind them to...
You need part no. 714.1.045.1A. Cost from Ducati approx. £4.90 It is the front wheel spacer fitted to the following; 620S ie 800SS ie Monster...
An air leak in the exhaust will cause it to pop and bang on the overrun and the newer Ducatis with air injection all do it with the OEM exhaust.
I'm not making excuses for him but he was on his second lap and there had been a short short shower of rain at that point by the time he got round...
It should but best check on the JPdiag forum for potential problems. http://jpdiag.xooit.eu/
You need JPdiag downloadable from here and you will need this kit of cables. That should allow you to do a TPS reset among other things.
I did the Ring once about 6 years ago. While I was there one of the guys with us came off his GSXR1000 at over 100mph when he hit a damp patch at...
I like the cold up here. It was -5ºC all day yesterday but it's reached a balmy 4ºC today. Doesn't do much for the riding season though :(...
These brushes are certainly pretty worn. I can't see the commutator very well in your photo but it seems to be in reasonable condition.
You are probably right about that since the tensioner bearings are neither a press fit nor have a large temperature differential between the inner...
C4 bearings are rated for high speed use, which the tensioner pulleys certainly have. So I'd be wary about changing to a different spec of...
Very nice Pete
Poor cold starting and worse when hot suggests a bad fuel/air ratio at closed throttle to me. Since it used to be ok and now isn't what has...
Good to know that you've found the cause. I never had problems with the RH switch gear but the LH one gave problems with accessing the menus. A...
