Separate names with a comma.
I very much doubt it.
A friend has a 2010 MTS1200 that has sat outside with a plastic cover over it every winter from November to March since new. It has never seen an...
And you'll be in danger of the clutch slipping. The adjustment of the screw is critical. Not enough free play and the piston won't fully return so...
Very carefully! With a sharp Stanley knife. The main body of the lamp has a rectangular panel along the back which the cables go through. You can...
PM Sent
Hmm. That's worth thinking about. Any volunteers?
There are actually 6 LEDs for the tail light and a further 10 for the stop light. A friend's packed up on the way to WDW2012 and he managed to get...
I had to replace the one on the ST4s a few years ago and the flywheel had to come off. The Multi looks to be the same and the procedure in the...
If you can get the frames ST pannier will also fit.
I've got a Classic. I bought it for it's looks and the wire wheels; reminds me of the bikes I grew up with. It's small and light and great fun to...
Mine is a 2010 with, presumably, the early grips where the wire on the twistgrip side comes straight out of the grip and rotates with the...
Mine were worn out at around 20K. I peeled off the rubber bits leaving the heating elements in place and replaced them Spidergrips SLRs....
I haven't got a DVT but the ones on my Scrambler are barely warm compared with the ones on my 2010 which would burn your fingers off on high. I do...
Aye, I suppose so but when the bike is stationary with no momentum to keep it turning it's more likely to just cut the engine.
My understanding is that the side stand switch will either allow the engine to run or it will cut the ignition. A poor connection at the switch...
I doubt if it'd due to a MAP sensor (there are 2, one each throttle body) as the bike would run crap but the throttle opening function shouldn't...
Sounds like the clutch system is leaking/drawing air. Best to get the dealer to sort it if it's still in warranty.
No. The seals are all inside the slave cylinder. The fluid on just about all Ducatis goes black, it's reckoned to be caused by the heat from the...
Yours is the new slave which has an anti rotation peg in the push rod. It is to prevent the push rod from spinning and damaging the seals. Oberon...
No worries. I pressed the outer bearing in using a socket that fitted to the outer ring of the bearing. The diagram is from the workshop manual...
