Separate names with a comma.
I've just been reading up about the Seimens ECU and you are right, the TPS does and auto-reset after 3 on/off cycles. So it looks like you'll be ok.
Hot glue gun?
The workshop manuals says to reset the TPS using the DDS "diagnostic instrument". If it self reset after 3 on/off cycles I'm sure it would say so....
As far as I know the Evo engine uses the Siemens ECU so JPDiag isn't going to connect to it. Balancing the throttle bodies shouldn't affect the...
I thought all carbon fibre was 'woven'. Maybe I'm just naive. I'd expect the glass fibre ones to be self coloured and red would the obvious one....
I suggested Diopa to someone (maybe you) on ducatipaso.org but it turned out that Diopa only do these in glassfibre for that model.
Belt & braces?
Trouble posting from my phone :mad:
Good find. I was aware that many Brembo parts could be got from KTM but didn't know which models have the radial m/cylinders
Or go to a locksmith and ask them to get you a JMA ZA14P. [IMG] I got one from my local locksmith for a tenner including cutting :)
Not on there own unfortunately. You have to buy a master cylinder "repair kit" [IMG] Pricey in the UK - Brembo - Radial Master Cylinder -...
If the bolts are fully tightened it shouldn't be leaking at the bolt holes as there is a gasket under the cover which should make the seal. It's...
Apparently it's normal for the engine warning light to come on when the fuel sensor fails. I think it comes on with the failure of any sensor. I...
Well at least you can be sure it's an electrical problem :rolleyes:
If there is over 12v at the coils and control boxes it's unlikely that the kill switch is at fault. A friend with a '96 900SS managed to kill both...
The 996 is an injection bike with a completely different ignition system from the old carbed SS. It has one crank timing sensor which, if faulty,...
Since only one cylinder is affected it's either a duff coil, plug, injector, the ECU (very unlikely as it will either spark or it won't) or a...
When did last have the valve clearances checked? I'd star with a compression check on both cylinders. If the compression checks out ok then start...
