Separate names with a comma.
In that case, I'll stock up - I love it...
Brasso might clean off muck and oxidation from stainless but it's not hard enough to polish the metal
Is the bike really tall then??
When ar When are you due out of hospital??
That's brave...
Must have had quite a lot of play then... I'm wondering if a judiciously placed cable tie might have a similar effect.
Does the bolt head contact the stand or just the washers?
Good point! My bracket seems ok and there is some play between bracket and stand but it's not enormous. The Multistrada guys are banding together...
Not necessarily. It shows there are are four clips with the same number but only two are at the bottom. The other two must be the leg heat-shield...
Yes the foot of mine does look pretty worn. A nylon pad bonded on could work, if it could be made to stick...
Looks like it could be 850.4.064.1A The diagram says there are 4 but only shows one at the bottom of the pipe, where it holds on a heat protector...
Sorry, no...
You'll need a pair of stainless clips that slide into place on the exhaust mounts and provide a thread. I would expect them to be on a parts...
Aha, yes, just after launch would be the only point at which it could be done. Full of explosive and fuel at that point though... Yes Baxter was...
I have the expensive American kit fitted to my 999 and it has transformed the way the bike starts. However, fitting it was a pain because the...
I believe it is common for 749s/999s to lean more than one might expect on their side stands and mine is certainly no exception. There is a thread...
Is it the same after the bike has cooled down? I wonder if air in the system could have heated and expanded. Weird...
How is that possible? Didn't the V2 go up pretty much into space and then come down again on a near vertical trajectory at enormous speed? Fighter...
Hope it's a typo on your part but on my bike at least, a 999, the tension should be applied anti-clockwise, not clockwise as you've said you did....
Yup, most large towns or cities will have a local bearing supplier on an industrial estate that will supply bearings at good prices.
