Separate names with a comma.
I believe the 996R has a carbon fairing with the intake left unpainted so it's not an insert. You could fit such a fairing (expensive though) but...
I've got a clarke lift, does the job nicely. I did have an oil leak at the lifting cylinder that stopped it working a couple of years back but I...
Top cleaning, reminds me that I need to get my car to the local £5 carwash as I can't read the rear plate...
No, I only remove them for sticking a CO meter up there to get a reading for mixture trim. The reason I had to get a tap in is because I lost one...
1/8 BSP, I had to run a tap through one of mine as it was too tight and and would probably have stripped either it or the plug if I had persevered.
Yes run it with the fuel off until it stops, but I wouldn't be taking it out for a short ride with the fuel off unless you want to push it back....
You can see it through the opening of the vertical (and probably the horizontal) cylinder but you can't access it without splitting the cases. I...
I can't really imagine this is a suitable application for carbon fibre - it simply isn't strong enough to have bolts tightened onto it. I like...
Can't say for sure that the 750 is the same but the 900 and 944 (ST2) don't have an 'O' ring on the horizontal cylinder, there is no groove for it...
I got some from MVS performance in Germany; https://www.mvs-performance.de/ in anodised billet aluminium. They have an ebay shop although the...
I've got an old Optimate and a newer Ctek. Haven't needed to use them much now that I've got Motobatt batteries in all my bikes as they hold...
You know it makes sense... ;)
If you mean the forks, 1098 and 1098SF may have the same forks? But the 1098 Ohlins are 54mm at the bottom yoke compared to 52mm for the Showa...
Sounds like voltage loss due to Ducati's marginal wiring. HID lights have a habit of cutting out/not lighting/staying lit etc. if the ballast is...
Don't think a TPS would do anything if you've got the standard ignition/igniters? I have an Ignitech ignition on mine and fitting a TPS to one...
My experience of buying a cheap frame and building it into a bike means an expensive bike. Unless you've really got most of the parts it'll almost...
I've never removed the swingarm from mine although I have removed the engine and the pivot/bolt pushed out really easily. But surely you could...
I've got a QB carbon hugger. Doesn't have the exhaust clearance 'dimple' and has never touched the exhaust, it does however tend to sag slightly...
K-tech; http://www.ktechsuspension.com/ based in the midlands, you'll not find better.
The one on my Monster is 12mm but it also has a 2.5mm 'hollowing' machined into it but it is not an original Ducati part so not sure if that...
