Separate names with a comma.
All my bikes are modified to some extent. I don't worry about originality, I modify them to suit me which is to make them perform/ride/turn/stop...
I'm sure it would work fine but just keep an eye on the condition, you don't want the bike ingesting bits of it if it starts to break down or come...
I fitted the thicker seal to mine at the same time as fitting a thicker (EVR) airbox. This makes the tank difficult to fit as everything is very...
Spindle for 1098 should be the same as 848, AFAIK other than the Ohlins versions they used the same forks and wheel. As for calipers, as long as...
Indeed, the red reinforcement cord is glass fibre, kevlar is yellow. AFAIK belts don't generally 'break', rather the rubber deteriorates causing...
It is generally considered best practice to increase the rear rather than decrease the front for several reasons, however it is...
Whilst increasing teeth helps with acceleration, it helps more with rideability IMO, I doubt the actual figures, 0-100 or whatever would vary much...
There is a serrated type of washer but it is a 'long' nut and needs to be ferkin' tight so shouldn't be coming undone and definitely not because...
Exactly this happened to mine. Many years back I had the clutch replaced by a dealer as part of an insurance repair. First ride out the clutch...
When fitting car tyres they replace them but they're push-in, cheap and considered disposable. I've never heard of replacing bike valves unless...
Any reason why you're fitting new valve stems?
To calculate the actual torque you applied see; Torque Wrench Extension Calculator Basically; M1 = M2 x L1 / L2 Where: M1 is the torque...
It broke because the bolts will be tightened to more than 38nm due to the longer leverage of using it straight where a setting of 38nm will...
I don't know what it is but my 916 tank is 'lined' with a black coating? It was like that from new so must have been done by Ducati. The Monster...
The axle is still 25mm and may use the same nut? but the 'fat' end that passes through the fork leg is bigger, IIRC 35mm vs. 30mm.
Showa forks will fit (Ohlins models need a larger, 56mm bottom yoke). AFAIK the brake offset should be the same but, you'd probably need the...
749 front wheel doesn't have the fitting for a speedo drive and I doubt it would be possible to machine it as you'd lose all the bearing housing?...
I used 'slic-tite' which is a fuel resistant paste but I think it's basically PTFE? Whatever it is, it hasn't leaked...
Best wishes for a full & quick recovery.
It will provide the correct torque if the spanner is at 90 degrees to the torque wrench. However If used in a straight line, as per the pic, you...
