Separate names with a comma.
It's not too bad, the worse part is setting the speedo (unless you have access to a dyno). I found the best way is to fasten a car sat-nav (or...
The intake cam is definitely not right, it's one tooth retarded so the intake valve is opening and closing too late. Hopefully it hasn't caused...
I would also recommend CJS. :thumbsup:
I did some research into this when fitting mine as the 1198 Ohlins do have 15mm offset but as I was using a 916 wheel I needed to source 15mm...
Allens are the people, I've been there a few times times (they're not far from me) and they've always had what I wanted in stock. Very...
Maybe but on mine the Brembo HPK discs are thicker than the originals and only around 1.5-2mm narrower than the caliper cut-out (test fitted...
If they were 15mm offset forks then the 10mm offset discs wouldn't fit, 5mm (per side) is way too much to make it fit. If the spacings of the...
When I rebuilt my Monster engine, I initially bought the 3 gaskets (centre & both side covers) but then used only threebond (gaskets have since...
Had a bit of a thing for 'Pepper'; [IMG]
That looks much better! what Ducati should have done in the first place IMO, same with the Scrambler. On another note, that's a small 'silencer'...
Could have wired it up properly so that the gear indicator shows neutral too...
A welded casing on a 700 mile engine?... :Stop:
Here you go; Share large files. Get comments. Make it great. | Hightail Spaces and yes I've just seen it is the same part no. :upyeah:
is the 998 swingarm any different to the 916?...
Does a 620ie have an immobiliser built into the dash/key?
You need to consider the artistic licence that Ducati used; when they say 'carbon bodywork' what they really mean is that it has a (single) piece...
The shape of the mounting bracket on the fork leg is quite different, apart from the spacing the 65mm mount is at a different angle. 40mm (916);...
I think the actual cans are the same on all Termis whether 45, 50, 52, 54mm etc. only the pipes are bigger up to the can. Of course there may well...
Latch bracket looks OK (same as mine) but the gap does look a little wide at the rear, is it possible the exhaust brackets are too low (try...
But if you were to use a 'speedo healer' that slows the cable drive by the relevant percentage (as above) then the same kmh speedo would...
