Separate names with a comma.
I decided to try them last year when I wanted rid of my 848. Had been offered £5,500 from an Indy dealer and webuyanybike offered me £4,500. I...
A very cleaver bloke managed to change the Perspex in his dash a year or so ago. Means striping the dash down a bit but he provided excellent...
B&Q have some decent mesh in. If not, plenty of car tuning shops have it or eBay. I've found heat resistant silicon sealer good for sticking them...
Hoping kais get the shock ready next week. If so, could be up for a ride out next weekend. :-)
Sounds about right! :upyeah:
No, the rear shock is getting re sprung for my weight, full service and a new main body as it's not much and it should look like new when done....
Hi mate. Need to lift bike on rear stand, fit the back part of the stand, remove rear stand. Then lift the front end with the under fork paddock...
Prototype stand made this aft at work. [ATTACH] [ATTACH] Needs a bit of work but just about there. Hope that Kais finish the rear shock next...
Have a look at the R/R connector. These often burn out and cause these types of problems.
Hi all. Set consists of 3 X exhaust heat shield bolts, 2 X M8 rear subframe bolts and 10 X shoulderd M5 fairing panel bolts. These are in mint...
Today must be Ducati 998 day! @Simon-Ducati has just bought a belter this morning too. :)
Nice! They look so much better with the mono seat. :upyeah:
Shame I'm a bit up the road from you (Belfast) until tomorrow, or I'd have popped down to see it.
Nice one, mate. You've been looking long enough for it.
Brilliant. Thanks a lot Neil. Would you know if it's the same top hat spacer as used on the subframe undertray, by any chance? I've got a few of...
evening all. Think I might be missing washer No. 34. The one that goes under the steering damper to frame mount. Would anybody know the thickness...
Should also say that while changing the seat over, change the two seat holder bolts for stainless jobbies. Can't remember the size M5 or M6 X 35...
^ agree. But this seat increases height by an inch. Not so good if you are short but probably best seat for normal height people. Being hard...
I found using a ground down 10 mm socket with a universal joint made the job easier for the front manifold. That with the ground and cut down 10...
GB moto do some decent ones and a bit cheaper than the others. :upyeah:
