Separate names with a comma.
Just checked prices. You're looking at 5 or 6 quid a piece for the genuine ones, depending on the colour of your bike.
Not daft money from Ducati, and you know they're right that way.
If you pm me the vin, I can check tomorrow for you and get definate model id.
That's the P8 ECU in a BP subframe. The P8 was used on the early mono and also SPS. The ECU in Robarano picture is the correct one for that...
Look up Moto-R in Ruthin. Rich is a good guy.
No need to replace. I recall way back when it was suggested they were, but not in recent times. The bolts are 10.8 hi tensile iirc and teh torque...
I've got some of the original US kits. Come with the tri wing bit in the pack.
The throttle stop voltage is somewhat academic... The critical setting is 150mV closed. The stop value can be anywhere across the figures you've...
Have you tried adjusting the trimmer in the ECU with minimal air bypass? You can adjust more coarsely to both cylinders, then fine tune the...
Blue is the old spec coolant. The new OAT spec is pink/red. They don't mix, or at least shouldn't be. The OAT has a longer life span of 4 years...
Under the latest schedules, the annual can be done independently of the desmo. Get the annual done, then wait til the 18k clicks up. The warranty...
There's also the option of new ones.... be more than a refurb I guess, but you can still get them for a couple of hundred a side including pads.
Haven't seen any around for ages now. Use Motul factory line. Latest OAT spec stuff
Doesn't look too out of place tbh. The last characters of each number are *'s not numbers. The engine one, looks to have a little casting...
Bolds is correct. MTS Enduro isn't affected
It's to drain any water that gets in thru the top, adjuster cap. If you want to use a front lift, you can get adapter plates that fit. Seen a few...
The hose recall is only for DVT. Multis. It wouldn't cause any oil water mixing either.. That's a lot of emulsion. Have you checked your coolant...
009001 is a '98 bike according to that VIN. It shouldn't have the earlier "Desmoquattro" scheme, but the later one. Nothing on the tank, "Ducati"...
most decals are still available from Ducati. If you have the vin, pm me and i'll find out for you. '98 was the changeover year. Many had the old...
As above... the stock finish is anodised so that would need stripping if anodising is to be done again. Powder coat would be border line on the...
