Separate names with a comma.
The 1200R is a dedicated kit as mentioned above. Not sure cans will swap over, but the mapping is definatley different. Drop me a pm about a new...
Use the pipercross OEM style ones in the air tubes. Better filters, better flow, seal the tubes fully and little chance of igniting over the bell...
Cans are easy to remove, the map needs dealer diagnostic tool. Owners, dealers can't be arsed but sell the cans for a bit of pocket money.
I used an ETI tank on my 1098. No issues at all. Fit, quality etc. top notch. Best thing I did to the bike by a long way. JHP were importing...
The map is held on the upmap key. When used its coded to the bike. One use only. If the key is used to put the mapping back to stock, then the key...
Cats are in the silencers. It's not an ECU swap but uses the upmap key. I'd try and get a complete set rather than just the cans. More money but...
There should be a patch of heat protection on there. You can get a new one from your dealer. Part number 46013681A for about £4 I'd suggest not...
Yep. Pretty much my findings. They've took everything other than a prolonged fuel spill we've thrown at them. I'd leave the miller and lathe on...
Just give it a good sweep. Knock any nibs off and lay the tiles. Because they are thin, bits of gravel need to be avoided as they cause small...
It's really good stuff.. This is what we've done. This has done 12 months of daily, hard use and all it needs is a wipe over with the mop every...
I went thru maybe 3 floor paint sessions in the workshop. Etching, epoxy etc... Didn't last too long at all before it started to wear, Mark up or...
They're only about £30 new Nelson. Bikesportdevelopments may have them to but not sure on cost there
Worth checking the hub clamp bolts aren't over tight to. 30nm is spec' but I've had them in where we've needed a breaker bar on them to free them...
848 is different as it runs the smaller wheel axle with 41/46mm nuts vs. the 55mm of the 1098/1198
The hubs are serviceable to limit, ie regreasing. The spacer on the LHS can be pulled out with a bit of patience and fresh grease packed in....
Double checked my sanity on this today. A later manual I have checked does in fact show the pulleys being done up after tensioning. However, IMO,...
The screws on the pulleys have nothing to do with tension. They are part of the procedure for replacing the belts, in order to set the cam timing,...
I have a brand new one for M900 98 onwards. Was trial fitted on a project bike but then the project went in a different direction. Stands me at...
There yours. Give us a shout when you're coming over. I'm closed over the holidays but can get out if it helps
Having a clearout...... 999 tank, Red, bare with a bit of corrosion inside. Would seal just fine, probably run as is, otherwise in decent nick £50...
