Separate names with a comma.
No worries. The O2 sensor is too big for the bungs so the exhaust gas needs to pass through the adapter, past the sensor then out to atmosphere....
It's an old Innovate MTX-L I've had for years. I bodged an adapter to use the bungs in the exhaust, here it is on my M900. [IMG] [IMG]
The hose is 5/16 (also the same for the in tank drain hoses) and the submersible standard is 30R10, the pump is 3 bar (43 psi) so go for a working...
It has been a few weeks and I have been chipping away at it here and there. The good news is that it is a runner, although not great at first as...
I've seen a 998 crankcase that had been patched with JB weld after the chain let go, wasn't a tidy job but has been there 10yrs or more now.
I see Davey Todd might be there too as a replacement rider
Ideas? Bare concrete, you can grind and weld on it, over spray is no problem and no worries if you feel like conducting a stationary load test of...
Correct, the RHP bearings used have a 15 degree angle
The Bosch part number is 0580453408, my local supplier said they were no longer available. They are a very common pump though, there is a thousand...
If you use a torque wrench in that method make sure it is 90 degrees to the wrench otherwise it'll act as a torque multplier.
I torque the horizontal idler then just do the vertical one by feel.
I went through a bunch of gloves but the fit was never right, I seem to be in between L and XL for most. I now have some RST Tractech Evo 4's and...
A few more jobs done Replacement RR fitted. I usually keep a mosfet RR in stock, I buy them cheap when they pop up so I have them for any new Duc...
