Separate names with a comma.
Absolutely, I think it was the most difficult thing I did during my renovation, well that and getting the swing arm bearings and retaining rings...
Roadkill, From Memory I could not get blind bearing puller on the bush, the shoulder was too small. Have a look at this post, I ended up...
Thanks again to M nine for the heads up about the circlip and how it went together. Well I did not hold much hope out for it being any better,...
[MEDIA]
[MEDIA] Apologies for any repeats
Roadkill, May be a little heat to soften, your going to have to gauge it not sure what paint you have on it. Mine was stuck with the original...
Mnine, thanks for reply. We'll I have new bearings but they feel looser than the originals. I will get them installed and full torque clutch nut...
I snook the profiles into job at work many moons ago. I will have a look to see if I still have the drawing file if you want to get some done....
M nine, Thanks for reply. First did this cure the wobble. Bearing are new in casings and all seem solid there. When you say shaft play do you end...
Ok, nearly there. Sorry its been a while. [ATTACH] Just a quick question. Clutch nut not fully torqued yet but when I turn the clutch hub the...
This is on my list - Hope you have great ride, a few pics wouldn't go amiss. Cheers Gaz
Thanks for all comments, very entertaining. Did a bit of travelling when younger (3 months in India & Sri Lanka on the way to Oz) so open to...
In the south of Spain on hols, had planned to nip over for a few hours on a day trip. Just wondered if anyone had called in, and if it was a...
I thought I was onto something today at a local bearing suppliers, right part number, but they ended up more expensive than Ducati. Cheers Gaz
Thanks for responses. Post 9 shows pitting on existing main bearings so yes will replace them this time. They are both RHP, Approx £200 pair from...
I think (will stand to be corrected) you measure the crank shaft and or use plastigauge and see if the standard bearings (red) gives desired...
Sorry. Initial post was con rod half round shell bearings. I got some of those sorted. The last picture was of one of the crank shaft angular...
When I rebuilt the engine the first I did not change the bearings, they had done approx 12k and I thought they would be OK. So during this latest...
Desmo , Yes I was going to fill the gap with three bond, but just wondered what bike it was from. I emailed Baines (who I bought it from ) but...
