Separate names with a comma.
Did not really like the c shaped bracket. Can't take credit for this saw it some where. Had to take the bolt out with mole grips which messes the...
That's great thanks both of you. Cheers Gaz
Got a photo of left ignition (red cable right white left) can't see from my photos and I think it was covered in tape which side black and yellow...
Ok peep your time is up. 1. Going 137/147Nm as per Ducati workshop manual. 2. Don't think the marks on the shaft line up with anything - looked at...
Another question. Just watch a video (Andy's MC Obsession) and noticed he put a shim in behind the clutch hub. I am pretty sure I kept everything...
Conflicting Clutch Centre nut torque values. Had a search on forum and both 140 & 180/190 are quoted. Haynes says 180/190, ducati workshop manual...
Desmo, This is the original set up. Just hoping it's the wrong chain guide. Cheers Gaz
Next one. I put the chain guide on and emediately it looked out of position. There is a raised section on chain guide which I presume corresponds...
Ok I know the following may sound obvious now. I think I confused myself by thinking neutral had its own position on the selector Drum. Doing a...
I think I could be OK if the following is true. Fully down position 1st gear White dot is at about 2 o'clock bottom picture. I had the switch...
Thanks Desmo. Ok indexes a bit better. I was turning the sprocket but was better turning it while changing gear. Gear selector adjusted to equal...
I hope I have not messed up. Tinkering this afternoon I thought I would check the gears, I am sure I did it before I re assembled engine. I...
I had some Simonize Tough Black which on test wasn't that tough it marked really easily, I had had it a while though. Also I had a go with some...
Desmo, I think that's a good option I thought I saw it somewhere on the USA Ducati sites but can't find it now. Handle bars dry blasted - not...
Roadtrip, Thanks My post 28. This was a diagram marked up to make sense of the wiring by myself and at a time where I thought this was an earth...
Still a bit unsure of this Reg/Rec connection. See diagram below. [ATTACH] To me and I am no Electrician - the connection at 8 (Reg/Rec) is not...
Roadtrip, Fair point, thanks. Cheers Gaz
Not really convinced about the earth to the reg/rec with the rubber well nuts isolating the frame. I thought I had seen somewhere running another...
Joe, Sorry to hear of your situation. I am sure you have looked at most thing, just done a search - can you contact a specialist company, maybe...
The front wiring loom went back OK, it followed the same bends in wire. [ATTACH] Is connector marked "A" the side stand switch. Oh and the...
