Separate names with a comma.
Calle3, The suspense is killing me, what was the problem. Cheers Gaz
Crystaljohn, Sorry I don't have a specific recommendation but I would say stay clear of the ones lazer profiled from plate. They obviously don't...
First bike I bought, good little bike enjoyed it before it got nicked from outside my girlfriends house - the bar-stewards. Cheers Gaz
andymaz, You need to use these two diagrams in conjunction with the link to Allens. The diagram is for a Yamaha (same carby I am sure most people...
As the the title says. Cheers Gaz.
What's the red stuff - if you don't mind me asking. Cheers Gaz
Ptomkrvr, Sorry, have you asked a question I have not responded to. Not sure what "Ref. 14:40, and 14:53" is. If I have missed something please...
Al, Thought when you set off tell us it was going to be a lot worse, glad it wasn't. Ride a bit faster people won't notice the damage. Cheers Gaz.
Martyn This gives an idea of how torque is affected depending on how you position the extension. It should show at 90 degree even if you change...
Ducati Cylinder Head Nut Tool (15mm) | eBay Ducati cylinder head torque spanner 900SS 750SS 600SS ST2 M600 M620 M750 M900 | eBay There is one...
Another correction. Sorry the Boge Spherical plain bearing is not not same as the Showa. Boge 12 26 16 12 (26 o.d.) Showa 12 22 9 11 (22 o.d.)...
Steve, I presume there is a domed spacer washer, which way round you fitting it. Quite sure its domed side to wheel. Cheers Gaz.
Al, Yes, a bit comfused about the O ring size. I looked the Hirschmann SCP12 on the boge and the sizes seem to be the same size as the Showa 12...
I saw this listing very soon after it was posted and could not believe it. It's been niggling at me since then. First, a bit of a preamble. I...
Result - free I like that price :upyeah: keep us posted, would like to know how rebuild goes. Cheers Gaz
Correction The statement about getting the shim thick ness and dividing by 2 is not altogether correct. This is only Ok if the crank case depth...
Thanks for replies all. Yes I had read the that if you replace the main bearings they must be preloaded, just looked at figure 0.15mm in haynes...
Thanks Mr.R thought that might be the case. Suppose I should have looked at my manual as well rather than just asking questions. Just had a look...
Al, The fit on the top frame lug is snug, I think the the lugs have been squashed in, as near the frame they are approx 0.5mm wider. The bottom...
Couple of questions if anyone could answer. I plan to strip and split my 900 engine. 1. If I don't pull the primary gear can I still spilt the...
