Separate names with a comma.
Nothing is moving Turbo. So push against the pistion? I swapped the slave and it was the same result
Thanks Both, My brain must be parked at the moment. Slipping off the slave and checking movement is so obvious ! Yep tried it and no movement on...
Rebuilding LH side of the bike and replaced Clutch Slave. Lever hard as a rock. Replaced spare slave and no pressure. Bled a bit and lever is hard...
You should get to 20K TBH
Can't say i missed this TBH. But needed Alternator holder, not tempted to put 270 nM through clutch or crank as some vidoes showed.
OK Well into it now, spring was broken. I changed both springs. Took the chance to repaint the case too. Made a two errors on assembly so had to...
Hi Derek Do you have any in 3D ! ;-) I have one and use it all the time
Hey Guys, I have seen the bobbin comment before. My understanding is that these are semi floating and should not move
Had this on and off for a while, changed discs 4 times but turned out EBC had the wrong model number. Only way to check is with a run out guage....
Thanks a lot. it was oily and with signs of polishing so I figured. I am thinking about getting new circlips but with everything shutdown it's...
OK so thanks again guys all back to gether then....I found a washer..bugger. I have racked my brains to think where it comes from. Can any recall...
thanks. got in there and circlip is off. slipped it on and pushed like hell to see if it would come off. Nothing. Case could push it off so not...
is the pump cover doing any holding of the pump?
Yep replies make sense..I shall have to try again. puller and then clean the cases again. Bit flimsy though, just that ting little circlip
As the title; I lined everything up. Greased the alternator spindle and gear shift gromet. Applied liquid gasket bolted it down and the water pump...
If I could get proper all around hard luggage for this bike I would probably buy one.
Indeed my mistake, its the silver Enamel that asks for it
Good, i used it on my Radiators. BTW did he cure it in an oven as recommended?
Yep I am running this now as my LH side had to come off to get at broken gear spring. I am using VHT paint and ticking off every mistake i can....
Where does she sleep now Finm!
