Separate names with a comma.
See my reply in the technical section.
I've heard of these Q/S problems too. I had a look my own bike to check how to turn the Q/S off. From the menu it wasn't obvious. I had too read...
It's different. The spherical joint on the 1260's quickshift link is adjustable, albeit only in ½ turns. 1200: [ATTACH] 1260:[ATTACH]
Wisbech, if I remember. Is that in Norfolk? My English geography isn't that great, I've hardly ever been there :grinning: Mick Walker also wrote...
Since 9th Dec 1976 when I took delivery of my new 860GTS, just over 45 years ago
It was open last summer. Is it just closed for winter or is it permanent?
Looks like Braemar to me. I'm in Angus.
And better quality
His may not be the cause but is worth ruling out as some replacement pick ups came with the wrong polarity.
That's not what I meant. For the horizontal cylinder swap the black and yellow wires round or the red and white, whichever pair is for the...
The connectors of the pick up to the Kokusan unit
I think that the pickup connections may be reversed on the horizontal cylinder
Check out Magnecor, I'm sure they will be available be in Australia. A pair of their KV85 cables for the 998 costs about £65 here....
When you changed the belts did you have any of the ignition system apart? Coils, ignition boxes, plug leads? If the plug leads or the connectors...
One of Ducati's requirements for affiliation is a supporting dealer. If the dealer withdraws support the club can no longer be affiliated. There...
On most models I can remove the fuel pump relay. This allows the starter to turn on the button without the sparks or injectors operating. So the...
Unlikely. On my Classic I picked it up from the back of the USB socket which has an ignition switched 12v supply.
As near as I can measure with the bars on, the distance between the fork leg centres is 205mm and the offset is 35mm. Be aware that the standard...
If the fuel pump runs at switch on the relay is OK. You should check for sparks. If none then possibly the crank sensor has failed. This would tie...
The mark on the distributor shaft should line up with the mark on the crankshaft. I think that's waht your 2nd picture shows. That should place...
