Separate names with a comma.
Time to start getting the 999 ready to go for an ecu remap/service/inspection at Clutton Hill. I was hoping to get the reflash after fitting what...
Bluey, I have a 748 (which I could not part with) and a 999. I have to say the 748 is a keeper for getting in the zone but the 999 is so much...
Just had similar on my 748 although the issue started with it cutting out momentarily over some bumps and the intermittent cut out meant it was...
CR did you get them from Wemoto, if so how long did it take and was it a special order out of stock when you ordered it? I am also considering a...
CR mine are Dzus caps under the engine(03 999), same as my 02 748S but silver rather than gold finish, not sure if they are oem however.
Wurth dry, chain/sprockets last loads longer and the only dirt on the back wheel is brake dust from the pads. Spray it on at the rear sprocket...
RC1, cold start for me has always been fast idle button in (whatever the weather), push start button - don't touch the throttle. It always fires...
Giler, bar ends are usually sold for 22mm od/17mm id or 25mm od/22mm id bars. They are pretty generic, round oberon 60mm are probably the...
Messer some more details follow. Check the fairing, I would suspect a racing (cheaper equivalent) fairing has been used and an air box from a...
MY02 748R were fitted with two piece unvented fairings similar to the MY02 748S, E and 998 base models although they did have different part...
Roadtrip, was it a hot day or were you in traffic when the fault first occurred, plus recently washed the bike maybe? Had a similar breakdown...
Derek, the points are shown on the wiring diagram within the generator. In reality they look something like the attachment with the condenser...
As Haydn says get someone to hold the bike on a level surface on both wheels, set the correct level then put it on the paddock stand to see where...
Should be a Yuasa YB16 AL-A2 (this is a normal lead acid battery that weighs plenty), not sure if the lugs are fully compatible with the later...
Conrad, new one was 0.68 ohms, spec is 0.65-0.7. When I rechecked the old one (with a new battery in the meter) it was reading 0.2-0.3, probably...
Conrad, just had similar issue on mine. Checked the coil resistance and the horizontal coil was fecked (resistance was way too low). New one...
I have tried a few and now just go with Brembo pads same spec as OEM but in a Brembo box instead of Ducati, plenty of sellers on line. They are...
Martin, spanner comes on flashing 50km before the service interval mileage is to be reached. It comes on solid at that interval and needs to be...
I have had a speed wobble/minor tank slapper on a ZX6R on a fast sweeping motorway bend, this was eventually diagnosed as an out of balance front...
Conrad, did you get a new or the same fault code from the dash 2nd time around? If you fix the fault the fault code is historical, not sure why...
