Separate names with a comma.
+1 for Oberon
I changed chain and sprockets at 15,600 miles. The chain appeared to fine and didn't need excessive tension adjustment. The rear sprocket also...
One of the Skyhook accelerometers is located under the cover, (item 32 below) so probably not a good idea to attempt to relocated it. It sounds...
Duct tape on the rims and around the brake line unions (which are the parts that will cause damage to the rims. When reassembling remember to...
Multistrada V4 Dash Simulator - enjoy :) Hope the real thing has less bugs!
Nothing wrong with a Honda! My Honda gets left in a damp shed all winter. I don't clean it before I put it away. I don't check it over...
Hopefully I'm moving house early next year, so these panels have got to go as part of my garage clear out.
Warming any pressurised aerosol can with heat gun is not a good idea. The data sheet for AFC-50 specifically warns of an explosion risk if the can...
I use a sprayer connected to a compressor to create a fine mist (I warm up the the AFC50 in the bowl first). After a good clean and making sure...
In the last 10 years, I’ve been lucky enough to own 4 Multi 1200s and clock up a total of 66,000 miles on them. I love the torque of the big...
Michelin Road 5 GT update I've done 3,250 miles on a set of the Road GT tyres and the rear tyre is worn out in the centre and cupped on the...
Front Tyre
Rear Tyre 2
Rear 1
I changed the chain and sprockets at 16,000 miles. The rear sprocket looked OK and the chain seemed good (not needing adjusting too often) however...
When I got my first Multistrada in 2010, I brought a Britool 70 to 330 Nm torque wrench which is 1/2" square drive for the rear wheel nuts. It...
My understanding is that each mode has a different baseline of damping settings with all modes set as default to medium. This would mean that...
I've now done a couple of thousand miles on my set of Michelin Road 5 GTs. I think the ride is maybe a bit harsher than the standard Road 5s...
I checked the tyres were seated true on the rims - they were. I then loosened off the front wheel spindle and pinch bolts and then did them using...
