Separate names with a comma.
Chap washed them, I did it again, but I bet theres still some there. Nasty stuff but its very fine glass so not as bad as sand
Having rebuilt some of these, it is better just to buy new. The rebuild for the piston is about 25 quid and the rebuild for the plastic elbow is...
Sorted?
Yes
Its cool, I have another set of cases I may use in future....
Its not an interference fit, and its been like that for a few years now, so I didnt worry. The studs are really hard to remove, they drilled it....
It looks it, but it all goes together ok. One of them was recoiled by a local engineering place, so it could be out a bit. The stud had broke
Getting there with the engine[ATTACH] [ATTACH]
Interesting looking bike :cool:
When I removed one, I used a large hose clip, to prevent the bezel from deforming too much. It did help, take it real slow.
The bezel is steel and not alloy, its a pig of a job and difficult to put back on as securely as it was. I have painted a needle with success...
A while since my last post. Been busy with life, but thought I would share my latest work. Got the shimming done after using the donor ST2 gearbox...
Bike colours https://www.bikecolours.com/
[ATTACH]
I have an ST2 lid you could cut up, its higher than the SS but the base is the same. £25 inc postage
Nice touch!
Merlins blood does a great job on wheel/caliper grime
The issue is getting them out, they can be in extremely tight, may need heated and to unscrew them you need a double nut at the end, which there...
Thats bad, first time Ive heard negative about them though
Ive found their products great, Ive had two looms and a starter. I havent however ordered anything else. Sorry to hear of this quite poor service
