Separate names with a comma.
Ah thought you meant engine side :joy:. Pulley bearings are cheap enough
I'm busy doing the bearings on my bevel now most of which have been in the engine for 40 years and they seem ok. However the mains on these bikes...
Celebrated my 60th earlier on in the week by seeing how much the Tuono would wheelie along the Helmsley TT. When the visor is down no-one can see...
[ATTACH] 300 miles round the Borders and St Marys Loch on the Tuono. Wheelie good fun, slightly spoiled by following an unmarked police car doing...
Apparently walked pole to pole.... [ATTACH]
Just for your reference here is the horizontal timing mark on my square case. Vertical cylinder mark disappeared after having a oil inlet welded...
I would have said the casting marks are tdc for each cylinder. To get an accurate reading you really need a positive stop in the plug hole,...
Not your every day bevel.... [ATTACH]
Cheers for the replies
[ATTACH]
Have you tried a big slave battery?
Thanks for all the replies guys, basically after overhaul items so didnt want a nasty surprise from HMRC when ordering abroad. Looks like...
Practical sportsbikes did an article on torque wrenches and calibration a couple of issues ago.
Check the onload cranking voltage. Is it not possible that the voltage is dropping too low for the ecu? You could always try bump starting it down...
Absolutely, but the same torque gives more tightening angle on the nut, and more bolt stretch. Get it wrong and you will pass the yield point, and...
You are correct, I should have said stretch figure, I will leave the original post as is so everyone can see I've made an arse...:joy: Nearly all...
Torque wrenches are guessing sticks at best. Try torquing 2 bolts up the same size, 1 lubricated and 1 dry and see the difference in tightening...
Thought it was 112 mph, but you can push past it if necessary with all sorts of alarms going. Then after a couple of years when everyone is used...
I'm going to go dirty old man here, but I usually stop to let horses past, 90% of the time the rider is female so you get an interesting view as...