Separate names with a comma.
Not for copper. It should be heated to cherry red and then quenched. The Annealing Process - An Easy Guide on how to Anneal Metals
I don't know, it will work but may not have the correct map for the MTS1000, but @chrisw can reflash it with the right one.
Strange. I had a similar experience yesterday while trying to reply to a post using my phone. I don't think it was a person interfering though,...
Most owners have found the gearing standard gearing to be to low, with 1st gear to low to be useable in everyday on-road conditions. Some have...
Jings! That's a lot of wear. Good they're sorting you with no problem.
I have been using it for a couple of years. It works but be aware that it doesn't work with every Android device. It works fine on my old Samsung...
That sealer looks really bad against the black cases. Yet Ducati used black sealer on my Scrambler which has dark gray cases. It is a lot less...
Either the neutral switch is broken or the wire from it has become disconnected, or is broken. So pulling in the clutch and pressing the starter...
Maybe a word with Ducati Glasgow would be in order.
The standard length chain is in fact 108 links ( I looked it up because I couldn't remember) and the standard rear sprocket is 40 tooth. So with a...
There is something not right there. The calliper bolts on mine are a good 1/2" away from the swinging arm. Are you sure the correct length of...
Yes, when you have reached the limit of your abilities that is probably the best option.
Really hard to diagnose this without getting a hands on the bike but you say the misfires is always the horizontal cylinder despite new plugs and...
OK, not plugs nor coils. That only leaves a wiring fault (intermittent poor connection) which is unlikely but not impossible, a faulty ECU (they...
The cat is getting very hot because it is burning the unburnt fuel caused by the misfire. Which shows that the injectors are working so it is an...
According to Stein Dinse website a new coil is €145.91, about £130. I think I'd rather lift the tank :p
I'm here OK but I think you guys are doing pretty well on your own. Your advice about swapping the coils is good and is easy to try. Scotland is a...
Why not?
I just checked the part numbers of the M797, which according to Nelly uses the same belts as the Scrambler, against the same parts for the M796....
Sorry, I don't know yet. I haven't opened up the Scrambler yet. I will doing a Monster 796 later this year and will take note of the belt runs and...
