Separate names with a comma.
Ah, thanks. I've left mine for about a year as I couldn't get it to budge. It's been unused for a looking time. I'll give that a try as it sounds...
[ATTACH] Mine was on it when I got it. I really like it. Believe it's Ricambi Weiss.
As regards Steve Bailey's link pipes I can tell you I have one if his frame braces for the headstock and the quality is very good. No experience...
IMO the best sounding cans are Sil. I have a full system which wasn't economical and is not quiet. You'll be very lucky to get a cheap standard SL...
What do you do with the nylon rod? I have a project engine and the rears off. The front is not and I have tried for some time with no success.
Really like what you have done. It's gonna look great and I like the rear light you went with. I converted my rear with a board of Leds in the...
Got mine at Image works, lacquered In, no problems
Rich, for the most part the issues I have been facing have been a bad coil from CA Cycleworks. In another post I talked about it. It's pretty much...
Thanks for the offer but I have plenty jets. I'll put the 55s in again as the screws are backed out quite a bit on the 52s
Duke, thanks for that, I've been in contact with Liam Venter over in NZ as he does a TPS and mount. I'll contact Frank MX as I have got several...
What TPS did you get?
Thanks Al, the carbs are staying. Perhaps in a parallel dimension my bike would've been fitted with Mikunis performance carbs as they seem like a...
I think the fuelling is actually ok. I've gone down to 52s on the pilot and it seems pretty good. I had to swap back to the Kukosan black boxes...
I asked below about FCR jetting however when I swapped my Ignitech over to the Kukosans it ran ok. It just doesn't seem to like the Ignitech much....
I'm running a 165 main just Now, which seems quite good. Everything else bar the slow fuel is as standard as it came. Question Is what's everyone...
Coils have arrived and installed. Bikes running great! A long standing issue has been solved all thank to Chris at CA Cycleworks for replacing...
That's a pretty good find!
Stu, I got a message saying they were being delivered tomorrow and thought they may be from yourself, however checking UPS tracking they were sent...
The needles are seating ok at the moment. I tested them when they were off the bike a couple weeks ago. Before that Ive had to clean them because...
