Separate names with a comma.
It's a tactic that's been used forever by dealers for various reasons, not least to 'suggest' that particular car/bike/boat is the best quality...
Thanks Dukedesmo:grinning: I'll have a look, maybe cancel the other one if they say it will be too long. Did you have a chance to look for any of...
I ended up biting the bullet and swapping out the bearings myself. I got the cases nicely warmed up in the oven, and left the new bearings in the...
Thanks Dukedesmo. As mentioned I'm a bit worried the existing shims put in with a gasket are already some of the thinnest available, so without a...
Why is this game never easy! One of the only pieces of kit I don’t have that I’ve often wish I did is a hydraulic press. My work contact has...
I’m still in a quandary about the centre gasket. I did get hold of a tube of Threebond 1104, with the plan of going commando, but then took a...
She's a beauty al right. I'm looking for exactly the opposite, a rough one to restore/slightly modify. Nasher.
Thanks for the input guys, I think as suggested I'd answered my own question, but was looking for some back-up. I'm going to order a gasket from...
Morning all. The crankcases are now split, and apart from one gear needing replacing in the gearbox I’m happy to say it’s just bearings and seals...
Hi all The gearbox in the mid 90's M900/900SS engine I'm rebuilding has some chips out of the sixth gear on the input side. Part No. 17210052A...
Whilst I was sorting the primary gear out I measured the bores a bit more accurately. Both are spot on 94.9mm. So: 94.9/2 = 47.45mm Radius A = π...
It’s off – Whoopee. Once I discovered it was on a taper I knew my 3 leg puller should be up to the job. I turned up a spacer to match the end of...
Only roughly, was just over 94mm, but haven't worked out the swept volume yet. Nasher
I have a Haynes, and have downloaded exploded diagrams of all the engine assemblies from the Stein-Dinse website, but don't have a 'proper' Ducati...
Had half an hour yesterday afternoon, so stripped the bits left on the outside of the crankcases, but came up against an issue. As hard as I try...
All It looks like this weekend I’ll actually get some time to split these crankcases, check and clean the insides. This is a long term project I’m...
When I first brought my 97 M900 a couple of years ago I found that the clamps that held the silencers on were binding up tight before actually...
The Barrels themselves as mentioned appear to have no wear at all, and don't even look as though they need 'glaze busting'. The bottom end feels...
I'll get the micrometer out in the morning. Thanks Chaps. Nasher
They are stamped 'V2' which I believe are the bigger valve SS or Monster Pre 97 jobbies?????? Nasher
